Sony BDP - S1 Operating Instructions Manual page 55

Sony blu-ray player user manual
Hide thumbs Also See for BDP - S1:
Table of Contents

Advertisement

The picture does not fill the screen, even
though the aspect ratio is set in "TV Type"
under "Video Setup."
, The aspect ratio of the disc is fixed on your BD/DVD. See
page 45.
Sound
There is no sound.
, The disc is dirty or flawed.
, Re-connect the connecting cord securely.
, The connecting cord is damaged.
, The player is connected to the wrong input jack on the
amplifier (receiver) (page 13).
, The amplifier (receiver) input is not correctly set.
, The player is in pause mode or in Slow-motion Play mode.
, The player is in scan mode.
, If the audio signal does not come through the DIGITAL
OUT (OPTICAL or COAXIAL)/HDMI OUT jack, check
the audio settings (page 47).
, The equipment connected to the HDMI OUT jack does not
conform to the audio signal format, in this case set "Audio
(HDMI)" in "Audio Setup" to "PCM" (page 47).
The sound is not output correctly.
, Check the "Audio Output Mode" in "Speakers" Setup
(page 51) if the AUDIO OUT (L/R) jacks or the 5.1CH
OUPUT jacks are used for audio connection.
No sound is output from the HDMI OUT jack
, Try the following: 1Turn the player off and on again.
2Turn the connected equipment off and on again.
3Disconnect and then reconnect the HDMI cord.
, The HDMI OUT jack is connected to a DVI device (DVI
jacks do not accept audio signals).
The sound volume is low.
, The sound volume is low on some BDs/DVDs. The sound
volume may improve if you adjust the "Audio Control"
setting in "A/V Control" (page 28).
Operation
The remote does not function.
, The batteries in the remote are weak (page 17).
, There are obstacles between the remote and the player.
, The distance between the remote and the player is too far.
, The remote is not pointed at the remote sensor on the player.
The disc does not play.
, The disc is turned over. Insert the disc with the playback side
facing down.
, The disc is skewed.
, The player cannot play certain discs (page 7).
, The region code on the BD/DVD does not match the player.
, Moisture has condensed inside the player (page 4).
, The player cannot play a recorded disc that is not correctly
finalized (page 7).
, The file on the DATA DVD contains characters other than
numbers and English alphabet.
The audio track file cannot be played
, The DATA DVD is not recorded in the MP3 format that
conforms to UDF (Universal Disk Format).
, The audio track file does not have the extension ".MP3."
, The data is not formatted properly even though it has the
extension ".MP3."
, The data is not MPEG-1 Audio Layer III data.
, The player cannot play audio tracks in mp3PRO format.
, Characters other than numbers and English alphabet are
contained in the file name.
The photo file cannot be played
, The disc is dirty or flawed.
, The DATA DVD is not recorded in a JPEG format that
conforms to UDF (Universal Disk Format).
, The file has an extension other than ".JPEG" or ".JPG."
, The image is larger than 4096 (width) × 4096 (height) in
normal mode. (Some progressive JPEG files cannot be
displayed even if the file size is within this specified
capacity.)
, The image does not fit the screen (the image is reduced).
, The photo file format dose not conform to DCF* (page 41).
* "Design rule for Camera File system": Image standards for digital
cameras regulated by JEITA (Japan Electronics and Information
Technology Industries Association).
, Characters other than numbers and English alphabet are
contained in the file name.
The file name is not correctly displayed.
, The player can only display numbers and alphabet. Other
characters may be displayed differently.
, Depending on the writing software used, the input characters
may be displayed differently.
The disc does not start playing from the
beginning.
, Random Play or Repeat Play is selected (page 26).
, Resume play mode is on (page 21).
The player starts playing the disc
automatically.
, The disc features an auto playback function.
Playback stops automatically.
, While playing discs with an auto pause signal, the player
stops playback at the auto pause signal.
Some functions such as Stop, Search, Slow-
motion Play, Repeat Play, or Random Play
cannot be performed.
, Depending on the disc, you may not be able to do some of
the operations above. Refer to the operating manual that
comes with the disc.
The language for the soundtrack cannot be
changed.
, Try using the BD's or DVD's menu instead of the direct
selection button on the remote (page 22).
, Multilingual tracks are not recorded on the BD/DVD being
played.
, The BD/DVD prohibits the changing of the language for the
sound track.
(page 36).
(page 40).
,continued
55
Troubleshooting

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents