Table of Contents
Advertisement
switch..it Installation Guide
Installation instructions
Caution Safety Instructions!
This manual is intended for qualified operating personnel. Electronic technical
knowledge is required for the handling of this device or system in order to avoid the risk
of electric shock or equipment damage. Perform only those referred to in this manual
Installation and Operating Instructions unless you are qualified on these instructions
also make interventions.
Always disconnect power supply before opening the frame!
This device operates in the specified voltage range without the need for manual
adjustment is required.
For the wiring different power cord can be used that meet the product safety
requirements of the country in which they are used. For this device, a power cord with a
protective conductor is required. The power cord must be rated for a nominal voltage of
240V / AC.
To ensure safety and permanent fire protection, all fuses may be replaced only by
identical fuses with identical electrical data for the corresponding fuse location.
Mechanical Installation instructions
To avoid damages on the 19" mounts of the frame, we recommend the use of 19" rack
mount rails.
Important!
In order to ensure a sufficient convection ventilation, we reccoment above and below
our frame 1-RU distance.
If the installation situation does not allow the recommended distance above and below
the device, the device can be equipped, as an available option with a fan and a cross
ventilation.
LAN integration
We recommend to use a virtual-LAN (V-LAN) for the IBT Interfaces inner core
"switch..it" components, like Frames and Panels.
Communication to the external components for example production switchers,
multiviewers or matrixes should be done via a router gateway.
IBT Interfaces, Schwalbenstr. 6, 63322 Rödermark
Tel.
+49 (0) 6074 / 69 64 16-0
Fax.
+49 (0) 6074 / 69 64 16-1
E-Mail:
sales@ibt-interfaces.de
Web:
www.ibt-interfaces.de
Subject to change
date: 09.12.2016
Page 3
Advertisement
Table of Contents
