Audio Settings - Sony 4-145-650-11(1) Operating Instructions Manual

Audio Settings

The default settings are underlined.
Audio Output Priority
Selects the jack type to output audio signals.
2-channel Linear PCM signals are output at
48 kHz maximum from output jacks other
than the priority jacks.
HDMI
Coaxial/
Optical
Multi Channel
Analogue
Stereo
Analogue
Headphones
Speaker Settings
To obtain the best possible surround sound,
set the speakers you have connected and their
distance from your listening position.
Then use the test tone to adjust the volume
and the balance of the speakers to the same
level.
This setting is selectable when "Audio
Output Priority" is set to "Multi Channel
Analogue."
54
Outputs audio signals from
the HDMI OUT jack.
Outputs audio signals from
the DIGITAL OUT
(OPTICAL/COAXIAL)
jack.
Select this when connecting
an AV amplifier (receiver)
via the MULTI CHANNEL
OUTPUT jacks.
Outputs audio signals from
the LINE OUT (R-AUDIO-
L) jacks.
Outputs audio signals from
the headphone jack
(page 42).
To set the speakers
1
Select "Speaker Settings" in "Audio
Settings," and press ENTER.
2
Select "Size" or "Distance," and press
ENTER.
3
Select a setup item using M/m, and press
ENTER.
4
Select or set a setting using M/m, and
press ENTER.
Size
Selects the size of the speakers.
• Front
Large
Normally select this
position.
Small Select this when the
speakers cannot reproduce
adequate low frequencies.
• Centre
Large
Normally select this
position.
Small Select this when the speaker
cannot reproduce adequate
low frequencies.
None Select this if you do not
connect a centre speaker.
• Surround
Large Normally select this
position.
Small Select this when the
speakers cannot reproduce
adequate low frequencies.
None
Select this if you do not
connect surround speakers.