Part I - Introduction - First Steps On Pronto! 40; Set Up And Key Location - Baum Pronto! 18 V4 Short Manual

9 Part I - Introduction - First Steps on Pronto! 40

Congratulations on acquiring your organizer Pronto!– no doubt you are keen to discover all that
Pronto! can do. The following pages do not constitute a complete handbook but are designed to
introduce you to the most important functions through practical examples, and to help you find
your way around the keyboard.
Everything you read here can be tried out immediately on Pronto!, thus helping you on your way
with Pronto!.

9.1 Set up and key location

So, back to Pronto!: how is it set out?
The upper surface has the keys of a normal small keyboard like you would find on a PC. It is also
possible to remove this keyboard and replace a 8 dot Braille keyboard. Both keyboards are modules
which can easily be changed by the user himself. To change the keyboard modules proceed as
follows:
1. In the rear part of the upper side, left and right beside the keyboard you find 2 interlock keys
2. Push simultaneously the right key to the right and the left key to the left. This unfastens the
keyboard module.
3. Lift the module and remove it.
4. Without the keyboard module the upper side of the device shows a deepening where the module
normally is placed.
5. To fasten the keyboard module, put the front edge of the module in the front part of the
deepening then let it down to the rear side and press it down.
6. The interlock keys fasten and the keyboard module is connected to the device.
You can change the modules even when Pronto! is switched on.
Now, we let Pronto! with the standard keyboard on it and explore the other parts and keys of the
upper side.
Left beside the keyboard you find a single round button. This is the REC Button to start recordings
21