LENCO IPD-4200 User Manual

Eng
Compliance with FCC Regulations
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1)this device may not cause harmful interference, and
(2)this device must accept any interference received, including interference
Speakerball with iPod docking
that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
IPD-4200
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
CAUTION
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
For information and support www.lenco.eu
14
80gms paper // folded size: 105(W)x146(H)mm IPD4200_lencoIB (US)
2009/9/28 VER 01