Table of Contents
Advertisement
3e-250 Bluetooth to RS-232 Cordless Adapter
Initially, set the properties to 9600 8-N-1 with flow control at Hard-
ware.
If you will be using the 3e-250 Adapter with test equipment and you
know that it requires a different baud rate than 9600, you can change that
later, using the Hyper Terminal session. Normally, the only things that
you will need to change are the baud rate and the device name.
Click OK to save your settings and select Properties from the File
dropdown menu.
In the Properties window, select the Settings tab. In the Backspace
Key Sends section, select the "Ctrl+H, Space, Ctrl+H" radio button. And
click on the ASCII Setup button.
In the ASCII Setup window, make sure you check the selection for
"Send line end with line feeds" and "Echo typed characters locally."
Checking these options will provide feedback when you issue commands
in hyperterminal. (This is very useful as a means of checking that your
command has been accepted.
Important Note: If you are working in Windows XP, and your hyper-
terminal software will not access the Bluetooth device, you may have to
set the MODE switches to the ON position for both DSR and CTS.
4
Advertisement
Table of Contents
