Faradite FAR-M360-*-VOLF Series Quick Start Manual

MOTION SENSOR 360 - VOLT FREE
FAR-M360-W-VOLF (WHITE) ----- FAR-M360-B-VOLF (BLACK)
OVERVIEW
The Faradite Motion Sensor 360
- Volt Free is a low profile passive
infrared ceiling mounted motion
sensor. It's designed for use with
home/building/lighting control
systems that have volt free / dry
contact inputs.
TECHNICAL DATA
Power supply 5V-24V DC @ 24V
(consumption) (3mA)
Solid state relay -
80ma
max load current
Solid state relay -
16 OHMS
on resistance
Solid state relay -
off-state leakage 1uA
current
Default state Normally open
Ambient 0-50 ° C
temperature (indoor only)
IP rating IP20
Range 5M
(Note 1)
Max mounting 3m (for optimal
height performance)
Motion output
timeout 1 second
(see motion
output diagram)
35mm (40mm Fire
Mounting hole
rated)
Push-fit AWG 20- 24 CAT5 /
connector CAT6 / CAT7
Standards EN 61000-6-1
EN 61000-6-3
X
Y
OBSERVATION AREA
At 2.5M it gives a 5.6M * 6.6M
detection area.
At 3M it gives a ~8M diameter, as
shown below.
The following conditions have to
be met to detect motion:
1.Movement speed: 1.0m/s
2.Target concept is a human body
(Min object size: ~700×250mm)
3. The temperature difference
between the target and the
surroundings must be greater
than 4 ° C when mounted at 5M
2.5M
2.5M Height - Beam Pattern
Y
X
6.6M
3M Height - Beam Pattern
8M
X
Y
NOTE: After applying power, the sensor will calibrate for roughly
MOTION OUTPUT
8 seconds; during this period no motion will be reported.
CLOSED
OPEN
Note 1: Please note that the specified range is 5m but under optimal conditions the sensor
might detect movement at a much longer range
ELECTRICAL CONNECTIONS
It is recommended to use CAT cable
to connect the motion sensor to the
control system. Stranded cable can
be used (20-24 AWG) but please
insert the supplied tool to open the
spring before inserting the wire.
1: Strip the cable back 6mm
2: Push into circular hole
3: To remove the wire insert the
supplied tool or a small screwdriver
in the slot behind the wire
Strip back
3M
Pull to remove connector from motion sensor
FIRE RATING
5.6M
The stand-alone Motion Sensor 360
- Volt Free is not fire rated.
To achieve a 60 minute fire rating to
BS 476: Part 21 1987, the optional
Fire IDR must be fitted to the
Motion Sensor 360 - Volt Free.
The Fire IDR is an optional extra.
EQUIVALENT CIRCUIT
VOLT FREE RELAY
VOLT FREE RELAY
-
0V/GND
+ 5V-24V DC
TIMEOUT
1 SECOND
Push in Remove
CLOSED DURING
MOTION
(NORMALY OPEN)