Servicing; Annual Servicing; Changing Components - Benchmark SYSTEMATE 2000 Series Design, Installation And Servicing Instructions

3.0 SERVICING

3.1 ANNUAL SERVICING

No annual servicing of the SysteMate 2000 is
necessary.
However, if required, the operation of the controls
and a hot water performance test can be carried
out when servicing the boiler to prove the
appliance is working satisfactorily and within
its specifi cation.
3.2 CHANGING
COMPONENTS
Free of charge replacements for any faulty
components are available from Gledhill during
the in-warranty period (normally 12 months).
However, if any component is damaged during
installation e.g. the A.C.B. , by incorrect wiring by
the installer, a new replacement must be ordered
and paid for.
After this, spares can be obtained direct from
Gledhill using the 'Speed Spares' service, or
through any of the larger plumbers merchants/
specialist heating spares suppliers.
Help and advice is also available from the
Technical Helpline on 08449 310000.
However, all components are readily accessible
and can be changed quickly and easily by the
installer using common plumbing practice.
If it is necessary to replace any of the pumps
fi tted to the appliance the pump head (motor
pack) only should be removed as recommended
by Grundfos. Assuming it is within warranty this
will be accepted by a merchant as being covered
by the Grundfos national service exchange
agreement, as long as it is a complete pump
i.e. alleged faulty motor pack and new base is
left with the merchant. It is important when a
pump has been replaced to ensure that any air
is adequately vented.
Page 29