Download Print this page

Kogan KASLIDORNGA Instruction Manual / Installation Manual page 8

60cm slideout range hood

Advertisement

Installation continued
EXTERNAL OUTDOOR DUCTING MODE
If you have chosen to operate your rangehood in "External Outdoor Ducting Mode"
you will need to follow the steps below:
1. Remove the aluminium grease filters from the underside of the rangehood. T urn the switch in the
centre of the motor housing to "External Outside Ducting" position.
2. Clip in the plastic Front Vent Cover (part ID 7, installation kit) over the vent holes on the front of
the rangehood.
3. Install the Flu Outlet Adaptor (Part ID 8, Installation kit) to the top of the rangehood
4. Install the ducting pipe (not supplied) to the outlet on the top of the rangehood and vent to
external air. It is recommended that the ducting pipe is 120mm in diameter.
INSTALLATION HEIGHT
For optimum performance, it is recommended that the rangehood be installed at a height of
between 650-750mm from the cooking surface. See Fig. 5 for detailed AS/NZS minimum distance
requirements.
Rear-mounting to the wall
• Using a spirit level, mark a horizontal line on the wall where the rangehood base will be, observing
all necessary clearances (Fig. 5). Check the required clearances in your cooktop/stove manual
and, should they be greater than those specified in Fig. 5, make sure to observe them.
Fig. 5
Minimum distance
– Electric: 600mm
– Gas: 650mm
Maximum distance
– Either:
Top of
cooktop
• Drill 4 holes of Ø8mm on the wall, as illustrated below (Fig. 6).
• Hammer the wall plugs into the holes, then insert two ST4x30mm screws into the lower wall
plugs. Tighten the screws, but leave a 2mm gap so that you can hang the rangehood on the
screws in the keyhole slots.
• Hang the hood to the wall screws, and make sure the hood is in balance and positioned correctly.
• Take away the Aluminum Filters, mark and drill another 2 holes of Ø8mm on the wall . (Safety
Screw Holes)
• Take back the hood and hammer the wall plugs, hang the hood again and fix the hood with two
ST4x30mm screws.
WARNING: Failure to install the screws or fixing device in accordance with these instructions
may result in electrical hazards!
750mm
8
Rangehood base

Advertisement

loading