Advertisement
Page 8
rek*---=*:-~J
4 - 4 0 x 114"
F L A T H E A D
S C R E W
B R A C K E T
/
-
-
S E T S C R E W
Refer to Pictorial 5 for the following steps.
(
)
Place the knob on the switch shaft so the pointer is toward
@
.
Tighten
the setscrew in the knob securely. You may now rotate the switch as
desired.
NOTE: You may wish to hang the Coaxial Switch on a wall or on an equipment
enclosure. A mounting bracket has been furnished for this purpose. Any two of
the opposite screws holding the rear cover plate may be removed to install the
mounting bracket in the following step. If you do not wish to use the mounting
bracket, skip the next step and also the third step (which tell you to install the
mounting bracket).
(
)
Note the numbers on the top cover and remove the two screws opposite
the
"2"
and the "C".
(
)
Place the blue and white label on the rear cover so the stamped numbers
are positioned as close to two adjacent screw heads as possible. Positioning
the label in this manner will permit you to read these numbers after the
mounting bracket is installed. NOTE: The Model Number and Production
Series Number of your kit are shown on this label. Refer to these numbers
in any communications you have with the Heath Company about this kit.
(
)
Install the mounting bracket on the rear cover plate with two 4-40 x 114"
flat head screws a s shown in the Pictorial.
This completes the "Step-by-step Assembly" of your Coaxial Switch. You will
be instructed to apply the decals from your label set during the "Installation and
Applications" section which follows.
Advertisement
