Control And Indicators; Main Power Switch; Main Power Button; Input Selector Switch - Accademia Laboratory Niko 1300M User Manual

fig 1.1
fig 1.2
fig 1.3
fig 1.4
www.accademialab.com
CONTROL AND INDICATOR

Main Power switch

The circuit bracker [fig 1.1] of the Niko1300M is
located in the power panel section of the rear
panel.This special circuit breaker is a fuse-less bracket
that operate only with the magnetic principle.
• OFF: the Niko1300M is isolated from that mains
power. Never turn off the circuit breaker before
wait 10 second from the standby
• ON: the Niko1300M check the system before
entering the standby mode. (2 second)

Main power button

The power button [fig 1.2] is located in the center of
the front panel.
• STANBY (status led blue) : the Niko1300M is not
isolated from that mains power. the amplification
stages is power off. Only in this phase is safe to
operate with the input and output connection.
• ON (status led green) : the Niko1300M now is
completely turned on. the amplification stages are
fully power on. The system check before unmute
the output last 6 second.

Input selector switch

The input selector [fig 1.3] switch is located in the
center of the rear panel. It switch between balance
(XLR) and unbalance (RCA) input.

Input gain selector

The gain selector [fig 1.4] is located under the input
selector switch. The gain selector is a input attenuator.
8 of 15
Rel: 1/8/2018 V1 RevA