Table of Contents
Advertisement
PROGRAM THE TIME RECORDER
Most of the procedures in this manual are
performed from the Time Recorder menu.
Refer to Time Recorder Menu below. Refer to
Time Recorder Function Buttons below.
Press SELECT . The unit changes into the program mode
showing
on the display positioned under the "TIME"
p
mark. (See Figure 8)
Figure 8
Time Recorder Menu
-:F1(&1=28A18()15>
TIME RECORDER FUNCTION BUTTONS
CONTROL
SELECT
Press SELECT to choose the desired
program setting mode. The selected
program mode is indicated by p on the
display.
CHANGE
Press CHANGE to cycle through the
options.
SET
Press SET to set the option. After an option
has been set, always press SET again to
return the unit to normal operation mode.
PAGE 7 OF 19
OPERATION
FUNCTION
SETTINGS
TIME
Set the Time Zone before setting the Time
(See Set Time Zone on page 6). Changing
the Time Zone will change the Time.
Example: Change the time from 9:08 AM to 10:09 AM.
Press SELECT until the
1.
2. "Hour" flashes. (See Figure 9)
Figure 9
Second
TIME
AM
SELECT
CHANGE HOUR
Press CHANGE until the Hour is "10."
1.
2. Press SET .
3. The flashing changes from "Hour" to "Minute."
(See Figure 10)
Figure 10
*)
CHANGE MINUTE
Press CHANGE until the Minute is "09."
1.
2. Press SET .
3. The "Second" starts to run from "00."
(See Figure 11)
Figure 11
*)
is under the "TIME" mark.
p
Minute
Hour
CHANGE
SET
1015 IH-2812
Advertisement
Table of Contents
