Replacing The Ribbon Cassette - U-Line H-2812 Operation Manual

REPLACING THE RIBBON CASSETTE

1. Open the unit. Refer to "Open Unit" on page 5.
2. Hold the ribbon cassette by its tab and pull the
ribbon cassette straight out to remove it.
(See Figure 57)
Figure 57
Remove Ribbon Cassette
3. Turn the knob of the new ribbon cassette in the direction
of the arrow (clockwise) to tighten the ribbon. Refer to
Tighten Ribbon Cassette below. (See Figure 58)
Figure 58
Tighten Ribbon Cassette
4. Install the ribbon cassette inside the unit as shown.
Refer to Install Ribbon Cassette below. Push the
ribbon cassette until it snaps into position.
Turning the knob on the ribbon cassette may
make installation easier. (See Figure 59)
Figure 59
Install Ribbon Cassette
PAGE 17 OF 19
OPERATION CONTINUED
Figure 60
5. Turn the knob of the ribbon cassette in the direction of
Figure 61
6. Close the unit. Refer to "Close Unit" on page 5.
Install the ribbon cassette so that the ribbon is
between the print head and the ribbon mask.
Printing will not function properly if the ribbon
is placed behind the ribbon mask. Refer to
Install Ribbon Cassette Between Print Head and
Ribbon Mask below. (See Figure 60)
Ribbon
Install Ribbon Cassette Between
Print Head and Ribbon Mask
the arrow to tighten the ribbon. Refer to Tighten Ribbon
Cassette below. (See Figure 61)
Tighten Ribbon Cassette
Print Head
Ribbon Mask
1015 IH-2812