Related Manuals for Panasonic BN-SW60ANL0
Summary of Contents for Panasonic BN-SW60ANL0
- Page 1 User's manual DTL Wireless Link Wireless Unit BN-SW60ANL0 Model No. Panasonic Corporation Connecter Solutions Company 1-15 Matsuo-cho Kadoma-shi Osaka, JAPAN 571-8504 @ Panasonic Corporation 2018...
-
Page 2: Main Specifications
Features The DTL Wireless Link(DTLWL) is the system to connect information network between carriages wirelessly. The DTLWL is integrated in the on-board train system and enables the ultra-high speed information network over a train. The DTLWL is capable of handling over 1 Gigabit data rate wirelessly and equips Ethernet ports as data transmission interface, therefore this is a best solution to replace from Gigabit Ethernet cable. - Page 3 Outline Cable Ground Protective Bent Connector...
- Page 4 Precautions ALWAYS FOLLOW THESE DIRECTIONS Be sue to observe these safety precautions because they are designed to protect you or Those around you from causing injury and to avoid unnecessary damege to the property. The symbols below indicate the levels of danger or damage that can be caused if the particular precautions are noto observed.
- Page 5 Warning When there is abnormality, stop using it immediately. If smoke comes out, smells, the outside deteriorates, as it is, it may cause injury due to fire or falling, damage to the equipment. Install in a place that can withstand the total weight. If the strength is insufficient, it may cause injury or accident due to falling.
-
Page 6: Installation Precautions
Installation Precautions Please refer to the installation manual for installation. Before installing and connecting this equipment, check the necessary peripheral equipment and cables and prepare. - Page 7 RED Information CE Declaration of Conformity Hereby, Panasonic declares that this “BN-SW60ANL0” is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. The declaration of conformity may be consulted at http://panasonic.xxx/xxxx/xxxx.pdf. Declaration of Operation This equipment has been so constructed that the product complies with the...
-
Page 8: Fcc Interference Statement
FCC Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. - Page 9 FCC Notice This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.