Advertisement
FUSE
4.5.
4.5.1.
The charger is equipped with two front panel mounted fuses. The output protection fuse on the left will interrupt the circuit in the
following circumstances:
a) Overload - too high a current to the battery.
b) Short circuit - clamps touch, or cross-connection to battery.
c) If the output fuse blows take the following action:
4.5.2.
The input protection fuse is situated to the right hand side of the control panel, see fig.3. If this fuse blows, replace only with a fuse of
the same value.
4.6.
THERMAL PROTECTION
4.6.2.1.
When a high current causes the charger to overheat the internal thermal protection will cut off the current. When the charger has
cooled sufficiently it will automatically reconnect.
NOTE: The use of an incorrect fuse will invalidate your warranty.
WEEE REGULATIONS
dispose of this product at the end of its working life in compliance with the EU directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
Disconnect the charger from the mains power supply.
Allow the unit to cool down, establish the reason for fuse blowing and correct.
Replace the fuse. DO NOT use a fuse with copper bridge or similar as these will damage your starter
charger. Refer to Section 3 'Specifications' for fuse information. We recommend that you hold 2 spare
fuses with the charger.
01284 703534
Original Language Version
sales@sealey.co.uk
CHARGE106.V3, 107.V3, 110.V3, 112.V3, 115.V3, 124.V3 | Issue:1 10/11/17
www.sealey.co.uk
Advertisement
