Applying Transforms - Orthogonal Devices ER-102 User Manual

Copy a selection
If you press the COPY button while the GROUP display is focused then the current
group's selection (but not the steps themselves) is copied to the clipboard. At this
point the GROUP display LED will start flashing. You can now navigate to another
group and paste the copied selection with the INSERT button. The pasted selection
will combine with the existing selection in the target group, creating the union of
the two selections.
Delete a selection
If you press the DELETE button while the GROUP display is focused then all steps are
removed from the focused group.
Rotate a selection
The ROTATE button will shift a group's selection later in the sequence by one step.
So if step #4 and step #12 are selected then after pressing the ROTATE button, step
#5 and step #13 will be selected. Holding the INVERT button while pressing the
ROTATE button will shift the selection earlier by one step.
Invert a selection
Group membership can be inverted by focusing a group and pressing the INVERT
button. All steps that were in the group are taken out of the group and all steps that
were not in the group are placed in the group.

Applying transforms

Each group has its own destructive transform that is accessible via the MATH button
and also non-destructive transforms that are accessible as the high/low modifiers.
Pressing the MATH button while the GROUP display is focused will show the de-
structive transform just like accessing the track transforms. When you apply a group
transform by pressing and releasing the MATH button, the transform will only alter
the parameters of those steps that are in the group.
You can edit the transform while holding down the MATH button and then apply
it by releasing the MATH button. Also, you can "pin" the transform edit screen by
pressing the VOLTAGE display button so that the screen stays when you release the
MATH button. In this case, press the VOLTAGE focus button (now displaying 'dONE')
again to exit from the transform edit screen. Apply the transform at any time by
pressing the MATH button. See the section on Math Transforms for a detailed de-
scription.
13