Table of Contents
Advertisement
17.8. Procedure for removing CD loading mechanism
1. Turn off by pressing power SW in the body.
2. Unplug AC power cord after the indication of [GOOD-BYE],
then disassemble the body.
17.9. CR16 mechanism disassembly procedure
17.9.1. Gear for servicing information
· This unit has a gear which used for checking items
(open/close of disc tray, up/down operation of traverse unit
by manually) when servicing. (For gear information, that is
described on the items for disassembly procedures.)
· For preparation of gear (for servicing), perform the
procedures as follows.
· In case of re-servicing the same set, the "gear for servicing"
may be took off because it had been used. So, the "gear for
servicing" must be stored.
1. Remove the gear attached to top cover of CD loading
mechanism.
2. Insert the hexagonal wrench (2.5mm) into the gear.
3. Disassemble
the
body,
mechanism.
4. Perform disassembly according to the following procedure
for disassembly.
17.9.2. Replacement for the disc tray
41
SA-VK81DGCS / SA-VK81DGCP
and
take out
CD loading
Hide quick links:
Advertisement
Table of Contents
