Cisco Catalyst 4500 E Supervisor Engine 6-E Series Installation And Configuration Note page 8

Supervisor Engine 6-E
Figure 1
1
1 Status LED
2
Reset button
3
Active Supervisor LED
4 Utilization LEDs
5 Compact flash port
The supervisor engine includes interfaces for SNMP, console, and Telnet, and provides management
functions, such as environmental status monitoring.
The Supervisor Engine 6-E provides the following features:
• 512-MB onboard SODIMM memory (upgradeable to 1 GB)
• 128-MB onboard flash memory (in addition to compact flash memory)
Compact flash port
•
USB port
•
320-Gbps switching capacity, 250 million packets-per-second actual forwarding rate (v4),
•
125 million packets-per-second actual forwarding rate (v6)
Support for up to 55,000 MAC addresses for Layer 2 switching (up to 64,000 entries, 16-way
•
associative lookup table)
• Support for up to 4,096 VLANs, 802.1Q VLAN tagging on all ports
• Up to 64,000 unicast and multicast forwarding entries, expandable to 256, 000 unicast and multicast
IPV4 forwarding information base (FIB) entries
• Support for Catalyst 4500 series and Catalyst 4500 E-series switching modules (except EoL models)
• Default Layer 2 forwarding at startup (hardware based)
Broadcast suppression on a per-port basis
•
Multicast suppression on a per-port basis
•
Unicast suppression on a per-port basis
•
EtherChannel at 10/100/1000 Mbps and 10Gbps
•
Protocol filtering on a per-port basis
•
Dynamic protocol filtering
•
Installation and Configuration Note for the Catalyst 4500 E-Series Supervisor Engine 6-E
8
Catalyst 4500 E-Series Supervisor Engine 6-E (WS-X45-Sup6-E)
2
3
4
5
8
9
6
7
6 Uplink ports
7
USB port
8
Console port
9 Management port
78-18337-01