Tapco Side-Winder Operating Instructions

S i d e - W i n d e r S n a p
Retainer Clip & C-Clip Installation
Kit Contains:
1 pc. 10911 - C-clip
1 pc. 10539 - 1/4 x 1 1/4" lg. Faspin
1 pc. 10913 - Retainer Clip
1 pc. 10799 - 1/4-20 x 1.0" hex washer head screw
Remove the Sidewinder from the box.
Attach the Retainer Clip to the front support with the 1/4-20 x 1.0" hex washer head screw. Use proper hole
as described in figure 1a. The hole will be 14 5/16" from the end if used on a PRO-14 series brake and 19.0"
from the end if used on a PRO-19 series brake. The retainer clip must run parallel with the front support
and point to the left. See figures 1a, 1b, and 1c below.
Install the Sidewinder back on the brake. Insert the C-clip in the front support and fix in place with the 1/4
x 1 1/4" lg. faspin. See Figure 2a at right.
1a
1c
29797 Beck Road • Wixom, MI 48393-2834
phone: (800) 521-7567 • www.tapcotools.com
© Boral Building Products Inc.
S t a n d
Tools Needed:
3/8" wrench
1b
2a
Tension Clip
Rail Clip
PRO-II
PRO-III
PRO 14™
position
PRO 2000 ®
PRO 19™
position
Locking
Knob
STEP 1
Set up is fast and easy. First, install Tension Clip with Locking
Knob onto middle support rail in correct hole position for your
brake. Do not tighten. See illustration above.
Loading the Coil Cradle
Cradle Roller
STEP 3
Remove Cradle Roller from Coil Cradle by grasping and unhooking
Roller Clips at each end. To load coil finish side UP see steps 4a &
4b. To load coil finish side DOWN see steps 5a, 5b & 5c.
Item #12053
T5280-CT 3/06
Side-Winder
Operating Instructions
Brake's Back Rail Rail Clip
Coil Cradle
Brake's Front
Base Hinge
Tension
Clip
STEP 2
Attach Side-Winder to the brake by inserting Back Rail Clip
into the brake's Back (Box) Rail and Tension Clip onto your
brake's Front Base Hinge. Tighten Locking Knob.
Finish Side UP
Roller Tube
COIL CRaDLE
NOTE:
Direction of Coil Material
Roller Clip
STEP 4a
To load coil finish side UP, insert Coil Cradle into center of coil
then attach Cradle Roller to Coil Cradle over TOP of coil.
™
Coil Cradle