Advertisement
Login with the Remote
Monitoring Account you
6
just created.
7
Click „+" to add a new plant.
Fill in the required data and
8
confirm with „OK".
Now add the AEG Net-
Stick: select your plant and
9
click on „>"
Click on „Device Info"
10
On the Collector page,
click on „+" to add an AEG
11
Net-Stick.
Find more materials on AEG inverters online at
www.aeg-industrialsolar.de/aeg-inverter-service
Input the name of the Net-
Stick (you can choose one
arbitrarily) along with the
Serial Number and Product
Key that you will find on the
Net-Stick packaging (and/
or on the product itself).
12
The Serial Number (1) is
written under the bar code.
The Product Key (2) is the
1
6-digit number.
Press „OK" to save the
settings and proceed.
Refresh the App and you
13
will find the newly added
AEG Net-Stick.
If you have more inverters in your plant, please repeat
steps 10 to 13 to add the extra Net-Sticks to the plant.
You can now proceed to configure the AEG Net-Stick
for Remote Monitoring via the App following the below
procedure.
4.3 Configuring the Net-Stick for Remote Monitoring
The AEG Net-Stick is by default configured for
Remote Monitoring. At this stage you can already start
monitoring your AEG inverter and can start from point
6 below. However, if you wish to double-check (for any
reason) the remote monitoring parameters, you can start
from point 1 below.
Connect your mobile phone to your router over
1
WLAN (the same router the Net Stick is physi-
cally connected to)
Launch the
AEG InverterControl App
2
and select „WiFi settings".
3
Click on the AEG Net-Stick
4
when the App finds it.
Check if the parameters
2
are correctly indicated as
below:
Net Mode: „Default"
SSID: „Default" (AEG WiFi)
5
IP Type: DHCP
Password: (empty)
Network Mode: „Client"
Remote Server IP:
14.215. 1 30. 1 86
Wait for approximately
6
15 minutes to allow for
synchronization.
Launch again the
7
AEG InverterControl App.
Select „Remote Monitoring".
Login with your credentials.
8
You have now successfully
installed your AEG Net-
9
Stick and you can start
monitoring your inverter.
5. MONITORING YOUR INVERTER
Launch the AEG Inverter-
Control App, select „Remo-
1
te Monitoring" and login
with your credentials.
Select your plant and click
on the „>" icon.
2
Access the general
interface of your plant. By
clicking on the monitoring
3
options you can access
the different reports and
monitoring parameters
6. FURTHER INFORMATION / CONTACTS
You can download further materials about AEG grid-tied
solar inverters at
www.aeg-industrialsolar.de/aeg-inverter-service.
Solar Solutions GmbH
Schneckenhofstrasse 19
60596 Frankfurt am Main
Germany
service@aeg-industrialsolar.de
Last updated: October 2018
AEG is a registered trademark used under license from Electrolux AB (publ).
4
Advertisement
