Samsung HW-NW700 User Manual page 13

If the device fails to connect
• If a previously connected Soundbar listing (e.g. "[AV] Samsung Soundbar NWxxx") appears in the
list, delete it.
• Then repeat steps 1 through 3.
Disconnecting the Soundbar from the TV
Press the button on the bottom panel or on the remote control and switch to any mode but "BT".
• Disconnecting takes time because the TV must receive a response from the Soundbar.
(The time required may differ, depending on the TV model.)
• To cancel the automatic Bluetooth connection between the Soundbar and TV, press the
on the remote control for 5 seconds with the Soundbar in "BT READY" status. (Toggle On → Off)
What is the difference between BT READY and BT PAIRING?
• BT READY : In this mode, you can search for previously connected TVs or connect a previously
connected mobile device to the Soundbar.
• BT PAIRING : In this mode, you can connect a new device to the Soundbar. (Press the
the remote control or press and hold the
5 seconds while the Soundbar is in "BT" mode.)
NOTES
– If asked for a PIN code when connecting a Bluetooth device, enter <0000>.
– In Bluetooth connection mode, the Bluetooth connection will be lost if the distance between the
Soundbar and the Bluetooth device exceeds 32.8 ft.
– The Soundbar automatically turns off after 5 minutes in the Ready state.
– The Soundbar may not perform Bluetooth search or connection correctly under the following
circumstances:
– If there is a strong electrical field around the Soundbar.
– If several Bluetooth devices are simultaneously paired with the Soundbar.
– If the Bluetooth device is turned off, not in place, or malfunctions.
– Electronic devices may cause radio interference. Devices that generate electromagnetic waves
must be kept away from the Soundbar main unit - e.g., microwaves, wireless LAN devices, etc.
button on the bottom of the Soundbar for more than
ENG - 13
button
button on
PAIR
SOUND
MODE
VOL WOOFER