Electrolux WAGL6S200 User Manual page 17

With the flap in the
position DOWN:
• Do not use gelatinous
or thick liquid
detergents.
• Do not put more liquid
detergent than the
limit shown on in the
flap.
• Do not set the
prewash phase.
• Do not set the delay
start function.
5. Measure out the detergent and the
fabric conditioner.
6. Carefully close the detergent
dispenser.
Make sure that the flap does not cause a
blockage when you close the drawer.
10.5 Setting a programme
1. Turn the programme knob and set the
programme:
• The related programme indicator
comes on.
• The indicator of Start/Pause -
Départ/Pause flashes.
• The display shows: the default
temperature, the spin speed, the
indicators of the programme
phases and the programme
duration.
2. If necessary, change the temperature,
the spin speed, the cycle duration, or
add available options. When you
activate an option, the indicator of the
set option comes on.
If you set something
incorrect, the display shows
the message Err.
10.6 Starting a programme
without the delay start
Press button Start/Pause - Départ/Pause
to start the programme.
The relevant indicator stops to flash and
stays on.
On the display the indicator of the phase is
operation starts to flash.
The programme starts, the door is locked.
The display show the indicator
10.7 Cycle time recalculation
10.8 Starting a programme with
the delay start
1. Press button Zeitvorwahl - Départ
Différé again and again until the
display shows the number of minutes
or hours of delay.
The related indicator comes on.
2. Press button Start/Pause - Départ/
Pause.
The appliance starts the countdown of the
delay start.
When the countdown is completed, the
programme starts automatically.
10.9 Cancelling the delay start
To cancel the delay start:
1. Press button Start/Pause - Départ/
Pause to set the appliance to pause.
The related indicator flashes.
2. Press button Zeitvorwahl - Départ
Différé repeatedly until the display
shows .
3. Press button Start/Pause - Départ/
Pause again to start the programme
immediately.
.
The drain pump can operate
for a short time when the
appliance fills water.
After approximately 15
minutes from the start of the
programme:
• The appliance adjusts
automatically the cycle
time to the laundry you
have put in the drum to
have perfect washing
results in the minimum
necessary time.
• The display shows the
new time value.
Before you press button
Start/Pause - Départ/Pause
to start the appliance, you
can cancel or change the set
of the delay start.
ENGLISH 17