Pyle PST30 Operation Manual page 2

DISPLAY DESCRIPTION
DISPLAY DISPLAY DESCRIPTION DISPLAY DESCRIPTION DESCRIPTION
1. To alter between Coarse and Fine tuning, select the
Coarse / Fine Tuning button to change from Coarse to
Fine adjustment.
Press again to switch back to Coarse. When in Fine
adjustment mode, "FINE" icon will appear on the
display.
2. Tach unit symbol, indicator rotation per minute.
3. Indicator symbol, represent in measuring.
4. Measuring data.
5. Low battery indicator symbol.
OPERATION OPERATION INSTRUCTION INSTRUCTION
OPERATION INSTRUCTION OPERATION INSTRUCTION
Power ON/OFF: Open the battery compartment cover
on the back of the unit and place the batteries in the
battery holder properly. Then press and hold the Power
Switch. The display will turn on and show the initial
factory default flash rate of 1200 RPM. Coarse tuning
is the default.
Manual Manual Adjust Adjust TACH TACH
Manual Adjust Manual Adjust TACH TACH
In COARSE adjust mode, press "up" or "down" button,
the value of flash will increase or decrease when the
range is greater than 1000 RPM or 10 RPM when less
than 1000 RPM correspondingly. In FINE adjust mode,
press "UP" or Down" button, the PHOTO TACH will
increase or decrease 1 RPM when greater than 1000
RPM, or 0.1RPM when less than 1000 RPM
correspondingly.
Auto Auto Auto Adjust Auto Adjust Adjust TACH Adjust TACH TACH TACH
Press "UP" or "Down" button for more than two
seconds to enter the Auto-adjust Mode. In COARSE
adjust mode, the value will increase or decrease when
the range is greater than 1000 RPM or 10 RPM when
less than 1000 RPM every 0.2 seconds. In FINE adjust
mode, the value will increase or decrease 1RPM
(>1000 RPM) or 0.1 RPM (<1000RPM) every 0.2
seconds
Note: Once the maximum of 19999 or minimum of 60
RPM is met while adjusting the rate, the device will
automatically stop at those thresholds.
TACH TACH TACH TACH measuring measuring measuring measuring
The Stroboscope will also stop motion at 2:1, 3:1, 4:1,
5:1, etc. This is normally referred to as harmonics. To
ensure unison, turn the dial until two images appear –
this will double the actual speed. Then lower the
flashing rate until a single and stationary image
appears - this is the actual true speed.
Checking Checking Checking Checking motion motion motion motion
For motion analysis, simply locate the actual speed as
mentioned above and then turn the dial slowly up or
down. This will give a slow motion effect allowing
complete inspection.
The The The The manual manual manual contents manual contents contents contents are are are are subject
The Company do es not
The The The Company Company Company do do does es not es not take not
accident accident accidents s s s that that that result result out out of of of of error out
accident that result result out
unit. unit. unit. unit.
subject subject to to to to change subject change change without change without without notice. without
take any responsibility for
take any take any responsibility any responsibility for responsibility for for
error error during during operation operation operation of of of of our
error during during operation
notice. notice. notice.
our our
our