Install the Sub-Base: Provide Power For battery power, Drill 3/16” pilot holes For 24 Volt AC power, in your desired location. Use supplied anchors for drywall or plaster. Connect Your Wires Wiring Terminations for model 71157P Terminal Function Description Installer Manual...
Page 3
Terminal Function Description NOTE: The “System Type” option will be configured in the Installer Settings section. The 71157P is a single stage thermostat and not intended for multi stage equipment. Heat Only or Millivolt 1 HEAT / 1 COOL Single or Dual Transformer...
Page 4
NOTE: The “System Type” option will be configured in the Installer Settings section. The 71157P is a single stage thermostat and not intended for multi stage equipment. 2 HEAT / 2 COOL Single or Dual transformer Hydronic Heat / 1 Cool...
Page 5
NOTE: The “System Type” option will be configured in the Installer Settings section. The 71157P is a single stage thermostat and not intended for multi stage equipment. 1 HEAT / 1 COOL - No Auxiliary Heat 3 HEAT / 2 COOL – Including Auxiliary Heat...
3 Quick Reference INSTRUCTIONS BACK NEXT DAY/TIME Thermostat Reset Button SYSTEM Button DAY/TIME Button PROG Button BACK Button* HOLD Button NEXT Button* RETURN Button FAN Button Quick Reference Instructions Up/Down ( / ) Buttons Outdoor Temperature PROG HOLD Installer Clear Button Battery Compartment BACK NEXT...
4 Installer Settings INSTRUCTIONS RETURN NEXT BACK RETURN BACK NEXT DAY/TIME NOTE: Shaded areas below do not apply to the 71157P. No. Installer Setting Factory Setting Comments Default Options Notes follow this table) (More information follows this table) COMM 7 PROG...
Page 10
No. Installer Setting Factory Setting Comments Default Options Notes follow this table) (More information follows this table) 90LIM 90-60 LIM 45LIM 45-80 LIM [note 7] PROG HOLD Additional options such as Service Monitors, setting the lock code, etc. are located in the User Settings –...
Page 11
2nd Stage Differential [note 2] 3rd Stage Differential [note 2] 10 1st Stage Fan Control [note 3] 11 Emergency Heat Fan Control [note 4] 12 Reversing Valve [note 5] 13 Auxiliary Fossil Fuel Heat Pump Control [note 4] This option can be overridden if setting an auxiliary heat balance point in Option 23.
21 Auto Changeover Dead Band [note 10] 22 Compressor Balance Point [notes 4, 11] 23 Auxiliary Heat Balance Point [notes 4, 11] NOTE: This balance point overrides the fossil fuel compressor lockout in option 13. If this option is set to gas and the outdoor temperature is over the auxiliary balance point, the compressor will remain on during a call for auxiliary heat.
Page 13
CTC Thermostats Limited Warranty Store this manual for future reference. 99 Washington Street Melrose, MA 02176 Phone 781-665-1400 Toll Free 1-800-517-8431 Visit us at www.TestEquipmentDepot.com 71157P-100-01...