For the on-the-go pet no-zip double pet stroller (10 pages)
Summary of Contents for Pet Gear ON-THE-GO Pet Series
Page 1
For The ON-THE-GO Pet ™ INSTRUCTION MANUAL DEsiGNEr str amp PG9916DBG/PG9916DCH/PG9916DSG/PG9916DTN To see our full line of products, visit us online at: www.petgearinc.com CUSTOMER SERVICE HELP DESK customerservice@petgearinc.com Toll-Free 877-752-9123 - Eastern Standard Time 8am-3pm, Monday through Friday...
PARTS LIST Check that you have all the parts shown BEFORE assembling your product. If any parts are missing, call Customer Service. Riser FRONT VIEW Dowel OF PARTS Ramp Designer Cover Top Stair Right Panel Left Panel BACK VIEW OF PARTS DEsiGNEr sTramP wiTH rEmOvablE COvEr •...
Page 3
ASSEMBLY INSTRUCTIONS Step 1. Place right panel on floor with PET GEAR Logo facing the floor and insert riser, lettered (B). Make sure there are no gaps between parts after inserting. (If inserting part is difficult put a little dish soap on doweled end before inserting.)
Page 4
ASSEMBLY INSTRUCTIONS Step 4. Insert dowel, (G). Make sure there are no gaps between parts after inserting. Step 5. Attach left panel. Align all holes before pushing panel down. Make sure there are no gaps between parts after inserting. Stramp shown fully assembled. DEsiGNEr sTramP wiTH rEmOvablE COvEr •...
Page 5
COVER INSTRUCTIONS Step 1. Unfold the Designer Cover, (H), and drape it over the steps. Elastic Strap Pull the elastic strap over the bottom of the StRamp. Bottom View Step 2. Pull the zipper down toward Step 3. Place carpet treads, (G), on top of the StRamp the floor.
Not intended to be used as a restraining device for aggressive or dangerous animals that dig, chew or paw aggressively. Do not leave your pet unattended. PET GEar is not liable for any damage caused by aggressive, destructive, immature or untrained animals. Do not use near an open or exposed flame. Failure to follow these warnings and the instructions could result in serious injury or death.