Advertisement
Available languages
Available languages
To remove the cutting guide, first
adjust the cutting length to 3mm
or 21mm and push the guide out of
the support lifting it up with your
thumb. (Fig. 3)
NOTE: The precision guide must
be placed like the cutting guides
but it is adjusted manually and
independently
of
wheel.
TURNING ON AND USING
To adjust the clipper's cutting
length, turn the grooved wheel (8)
up or down.
The selected length is displayed on
the right or left side of the clipper.
Switch the ON/OFF button.
You can change the cutting length
at any time.
Thanks to the SMART ADJUSTING
SYSTEM, the length of the cut is
maintained even if the angle of
the clipper varies, so it guarantees
precise result.
CUTTING
TECHNIQUES
ADVICE FROM THE EXpERTS
• Use the clipper on clean, dry hair.
• To familiarize yourself with the
clipper, begin with the cutting
guide for a longer cut, then, if you
want a shorter cut, adjust it by
pushing the knob. You will soon
know the lengths of each guide
and each position.
• Always move the clipper against
the direction of hair growth.
• Begin at the nape. Place the guide
on the scalp and move the clipper
toward the crown of your head.
Move your clipper slowly, pointing
the teeth of the guide slightly
upward. Keep the clipper in contact
with your head at all times. (Fig. 4)
• For the crown of the head, move
• For the finishing touches, that is,
the
grooved
• If you want a length greater than 30
- Work without a cutting guide.
- Take up a small section of hair with
- Move the comb or your fingers
- Cut your hair along the comb or
- Remove the cut hair using a comb
Using the thinning guide
Switch the clipper to the 'THIN'
AND
position. The thinning guide is in
front of the blades.
This technique allows you to thin out
hair to make styling easier.
The technique is particularly good
for the crown of the head where hair
is usually thicker.
To thin you hair, take a section of
hair (rest your little and ring fingers
on your scalp, using the middle
and index fingers to set the length),
hold 1 to 2 cm below the cutting
length. Then, using the clipper, cut
the section of hair steeply and at an
angle to create a saw-toothed 'edge' .
MAINTENANCE
Remove the cutting guide after each
use.
8
from front to back, that is, from
your forehead to the crown of your
head.
around the nape and sideburns, use
the clipper without a cutting guide.
Turn your clipper over and move it
from top to bottom. (Fig. 5)
mm, or if you are experienced, you
can create 'comb' or 'finger' cuts:
a comb or in your fingers.
along the section of hair to the
desired length.
your fingers.
and check the evenness of the cut
regularly. (Fig. 6)
Advertisement
