Advertisement
8.
Attach the two-wire plug to the two prong connector.
Attach the four-wire plug to the four-wire connector.
9.
Insert and connect the three 9-volt batteries to the
battery terminal connectors. Secure the batteries in the
battery holder compartment and make sure the wires
point toward you as you secure them in place. (Battery
connectors should point toward the circuit board).
10. Perform an Install function with a valid TRACcess
eKEY. Refer to the TRACcess eKEY user instructions
for step by step operation.
11. Test the lock operation using the TRACcess eKEY.
Refer to the TRACcess eKEY user instructions for step
by step operation. Test the lock first with the door open
and then with the door shut to ensure the lock strike
catches the door frame.
12. When you test the lock with your key, the LED at
the top of the interface will flash green, indicating
the door may be opened. If the device is a TRAC-
Station BT programmed for TIMED mode, the light
will remain flashing for a preprogrammed period
of time, during which the door may be opened. If
the device is a TRAC-Station BT programmed for
LATCHED mode, once the light flashes green, the
door may be opened until the lock is reset. If it is
programmed for LATCHED mode, be sure to reset the
lock.
13. Once you have tested the lock, place the lid on the
back of the electronics enclosure and position the logo
directly over the battery pack. Insert the provided six
#4 × 1/2 in. (13 mm) flathead screws into the predrilled
holes. Hand-tighten the upper right corner screw and
continue hand-tightening the remaining screws in a
clockwise order. Do not overtighten the screws, as
Figure 2. TRAC-Station BT assembly
Exterior WTI
Interface
Plate
Lockset
4-wire plug
Supra: 800-547-0252 • www.suprasystems.com
doing so may damage the electronics enclosure and
prevent the lid from being securely fastened.
14. Record the device serial number and location.
Battery removal/disposal
This product contains three 9-volt batteries if it is a TRAC-
Lock BT or three AA batteries if it is a TRAC-Station BT.
The batteries should be periodically replaced. Replacing the
interface is a good time to service the batteries. To remove
the batteries, do the following:
1.
Remove the lid from the electronics enclosure.
2.
Pull the batteries out of the slots.
For proper recycling, dispose of all batteries as required by
local ordinances or regulations.
FCC
The device, Assy, Bezel, WTI, part number 10102917G1,
complies with part 15 of the FCC rules. Operation is subject to
the following conditions:
1.
This device may not cause harmful interference.
2.
This device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
2002/96/EC (WEEE directive). Products marked with this
symbol cannot be disposed of as unsorted municipal waste in
the European Union. For proper recycling, return this product
to your local supplier upon the purchase of equivalent new
equipment, or dispose of it at designated collection points.
Interior
Electronics
Mounting
Enclosure
Plate
Exterior
Mounting
Plate
Advertisement
