PrimeCables Cab-CIS316-L Operator's Manual page 3

IMPORTANT SAFETY INSTRUCTIONS
4. Do not abuse the cord. Never use the cord to carry the tools or pull the plug from
an outlet. Keep cord away from heat, oil, sharp edges or moving parts. Replace
damaged cords immediately. Damaged cords increase the risk of electric shock.
5. Be sure to use electrical supplies that are suitable for the conditions. If working
outdoors, use extension cords rated for outdoor use, - this reduces the risk of
electrical shock.
6. If you have to work in a damp location, be sure to use a ground fault circuit
interrupter (GFCI) protected supply. This will help reduce the risk of electrical
shock.
ELECTRICAL SAFETY (CONT.) - EXTENSION CORD USE
Make sure the cord is clear and secure - do not step on, trip or otherwise damage
or stress the cord.
Don't use an extension cord unless you have to - use of an improper extension
cord can result in re, shock or electrocution.
Two-wire cords can be used with 2-wire or 3-wire extension cords. Only round
jacketed U.L. (Underwriters Laboratories) listed extension cords should be used.
If you are going to use an extension cord outside, make sure the cord is
manufactured for outdoor use.
NOTE: Most cords used for outdoor use can also be used indoors. The letters
"W" or "WA" on the cord jacket mean the cord is suitable for outdoor use.
An extension cord must be of the proper gauge (wire size) - AWG or American
Wire Gauge to be used safely, prevent power loss, and prevent overheating.
NOTE: the smaller the wire gauge number, the greater the capacity of that cable;
for instance, 16 gauge has more capacity than 18 gauge. If you must use more
than one extension cord, be sure each extension has at least the minimum
required gauge size.
SAFETY PRECAUTIONS FOR IMPACT DRIVER
CHARGING THE TOOL
Please use the correct voltage.
BEFORE ATTEMPTING TO CHARGE YOUR TOOL, THOROUGHLY READ ALL
THE SAFETY INSTRUCTIONS.
1. The tool is not fully charged. Before first use, the tool requires 5-7 hours charge
time to be fully charged. Subsequent recharging needs 3-5 hours for the tool to
be fully charged.
3