Table of Contents
Advertisement
W10000-en.book Page 28 Thursday, October 19, 2006 1:45 PM
4.
OSD Position H: Adjusts the horizontal position of the OSD.
5.
OSD Position V: Adjusts the vertical position of the OSD.
6.
Reset Settings: Returns all image settings of the current source to the factory preset values.
Setup menu
This menu contains items necessary for basic image setup.
1.
Language: Sets the language for the OSD menus.
2.
Mirror: The projector can be installed on a ceiling or behind a screen, or with one or more mirrors. There
are four settings for choice. Contact your dealer for the ceiling mount bracket if you need to install the
projector on a ceiling.
3.
High Altitude: This item is designed for those who use the projector in extreme environments, like high
temperature or high altitude. We recommend you select Yes when your environment is higher than 3000
feet, or is hotter than 40°C.
Operation with Yes selected may caused a higher decibel operating noise level because of increased fan
speed necessary to improve over-all cooling system and performance.
If you use the projector under other extreme environments excluding the above, it may display auto shut-
down symptoms, which is designed to protect your projector from over-heating. In cases like this, you
should switch to Yes to solve these symptoms. However, this is not to state that this projector can operate
under any and all harsh and extreme environments.
4.
Black Level: The grayscale video signal is measured in IRE units. In some areas which use NTSC TV
standard, the grayscale is measured from 7.5 IRE (black) to 100 IRE (white); however, in other areas which
use PAL equipment or Japanese NTSC standard, the grayscale is measured from 0 IRE (black) to 100 IRE
(white). We suggest that you check the input source if it is with 0 IRE or 7.5 IRE, then select accordingly.
5.
Keystone: Corrects for trapezoidal distortion resulting from the angle of projection. It can provide
correction of up to ± 12 degrees.
6.
Pattern: It will be displayed with the aspect ratio setting made using the Aspect Ratio function of the
DISPLAY menu. Use this pattern when installing the projector, even if there is no input signal. Use it to
adjust the image size and the focus.
7.
Lamp
Lamp Type: Sets 250W or 200W as the power type of your projection.
•
Lamp Hours:
•
i. Lamp Hours: Shows the total time of the lamp has been used.
ii. Lamp Rest Rate: Shows the percentage of the rest lamp life.
Reset Lamp Timer: Resets the lamp timer. This should only be done after the lamp has been replaced.
•
8.
Dust Filter
Dust Filter Hours: Shows the total time of the filter has been used.
•
Reset Dust Filter Timer: Reset the dust filter timer. This should only be done after the filter has been
•
replaced.
Advance menu
1.
Advanced - 20 step IRIS:
2.
Whisper mode: This projector features a whisper mode which achieves an astonishing low 23dB of emitted
noise during operation—the same level of noise as someone whispering in your ear. Even normal operating
noise of 25dB is little more than a whisper. To switch the whisper mode on or off, press the
on the remote control or projector repeatedly.
3.
Edge Optimizing: Sharpens the edges on an image. It helps highlight the details on an image or restore
details that have been blurred. To enhance the picture edges, press the
or projector. The higher the setting, the greater the edge performance.
28
Menus
See page 14
for more information.
Adjusts the contrast ratio toward Low or High.
See page 21
for more information.
or
button
or
button on the remote control
Advertisement
Table of Contents
