ITEM #0745365
WALL CONTROL AND REMOTE
MODEL #41179
Harbor Breeze
is a registered trademark
®
of LF, LLC. All rights reserved.
ATTACH YOUR RECEIPT HERE
Serial Number
Purchase Date
Questions? Call our customer service department
at 1-800-643-0067, 8 a.m. - 6 p.m., EST, Monday -
Thursday, 8 a.m. - 5 p.m., EST, Friday.
PACKAGE CONTENTS
A
B
C
D
E
F
G
H
Remote
Wall Bracket
Battery
Receiver
Push-on
Wall Control
Decor
Standard
Qty. 1
Qty. 1
Qty. 2
Qty. 1
Connector
Qty. 1
Plate
Plate
Qty. 2
Qty. 1
Qty. 1
HARDWARE CONTENTS
BB
CC
AA
Wire Connector
Plate Screw
Mounting Screw
Qty. 3
Qty. 2
Qty. 2
PREPARATION
Tools required for assembly (not encluded): Electrical Tape and Phillips Screwdriver
SAFETY INFORMATION
Read instructions completely before installing the remote.
WARNING: If the color of the household supply wires is different than what is referred to in the instructions below, a
professional electrician should determine proper wiring.
CAUTION:
• Do not install in damp locations. For indoor use only.
• Do not use with fans that have integrated remote controls.
• Be sure the outlet box is properly grounded or that a green or bare (ground) wire is present.
• This unit is intended to control a ceiling fan with electrical source of AC 110/120V, 60Hz.
• To reduce the risk of fire or electric shock, do NOT use a full-range dimmer switch to control the fan speed.
• This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the
receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an
outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/
TV technician for help. Any changes or modifications not expressly approved by the grantee of this device could void the
user's authority to operate the equipment. FCC ID: KUJCE 10409, KUJCE 10003