Advertisement
Quick Links
OPERATION AND INSTALLATION INSTRUCTIONS
YOU MUST SET CEILING FAN MANUAL SWITCH TO HIGH SPEED AND LIGHT
KIT (IF ANY) TO ON POSITION BEFORE OPERATING REMOTE CONTROL.
IMPORTANT POINTS TO REMEMBER:
1.
Read and save these instructions.
2.
Please note that all fixed wiring appliances should be installed by a qualified electrician.
3.
The supply to the remote control receiver should be connected through a mains switch, i.e.
existing wall switch.
4.
Disconnect from power supply at wall switch before working on remote control receiver or
ceiling fan.
5.
Install receiver into the ceiling fan canopy of the fan to ensure proper protection.
6.
This unit is to be used for the control of ceiling fan and in an AC120V 60Hz power supply only.
7.
Do not install in damp locations or immerse in water. (For indoor use only.)
8.
Do not pull on or cut leads shorter.
9.
Do not drop or bump the unit.
10. PLEASE NOTE: The battery will weaken with age and should be replaced before leaking
takes place as this will damage the transmitter. Dispose of used battery properly, and keep
the battery out of reach of children.
11. CAUTION: To reduce the risk of fire or injury, do not use this product in conjunction with any
variable (rheostat) wall control.
INSTALLATION INSTRUCTIONS
CAUTION: INCORRECT WIRE CONNECTION WOULD DAMAGE THIS RECEIVER.
1. Ceiling fan must be set at HIGH speed and light kit (If any) at ON position by pressing the
"Light Switch" after installation.
2. Once the connection has been made, the receiver inserts into the drop rod hanging bracket.
The canopy comes up to cover the receiver and bracket.
CEILING FAN REMOTE CONTROLLER
(Please keep this instruction pamphlet.)
IMPORTANT
Advertisement
Related Manuals for Harbor Breeze KUJCE9603
Summary of Contents for Harbor Breeze KUJCE9603
- Page 1 CEILING FAN REMOTE CONTROLLER OPERATION AND INSTALLATION INSTRUCTIONS (Please keep this instruction pamphlet.) IMPORTANT YOU MUST SET CEILING FAN MANUAL SWITCH TO HIGH SPEED AND LIGHT KIT (IF ANY) TO ON POSITION BEFORE OPERATING REMOTE CONTROL. IMPORTANT POINTS TO REMEMBER: Read and save these instructions.
- Page 2 LEARNING PROCESS 1. This unit finished learning process inside manufactory, if replace transmitter or receiver, user need to redo learning process before using this unit. Receiver could remember up to 5pcs transmitter. 2. After installing the unit and power on, open battery cover (with battery, DC12V/A23 1pc, installed) and press and use a ball pen to hold ”LEARNING”...
- Page 3 Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to operate the equipment. FCC ID：KUJCE9603 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.