Remington iCoffee EXPRESS Customer Care Manual page 7

2. Place a cup/mug (10 oz minimum) on the DRIP TRAY directly below the LOWER BREW JAW.
3 Press the OPEN
merely press it back down to its original position without adding a K-Style Cup. Once closed,
the BREW BUTTON will start flashing.
4. Press the flashing BREW BUTTON. It will stop flashing and the pump will begin filling the HOT
WATER BOILER TANK.
5. Once the HOT WATER BOILER TANK is full, the RED HEATING LIGHT will illuminate and the
Boiler will begin heating the water to the ideal brewing temperature. This process will
take approximately 2.5 minutes. Once the hot water has reached the perfect brewing
temperature, the RED HEATING LIGHT will turn off. Now open and close the UPPER BREW
JAW without adding a K-Style Cup. The BREW BUTTON will begin to flash.
6. Press the flashing BREW BUTTON, the brewer will dispense approximately 1 to 2 ounces of
hot water into your cup.
7. When the cycle is complete, merely discard the dispensed hot water.
Congratulations! You have now primed the brewer and it is ready to make your favorite
hot beverage following the steps below.
NOW YOU'RE READY TO BREW YOUR FAVORITE BEVERAGE!
1. If the Brewer is not already on, press the POWER BUTTON. The POWER BUTTON and
the BREW BUTTON will illuminate.
NOTE: After 2 hours of non-use, the brewer will go into an energy saving mode.
After an additional 26 hours of non-use the brewer will automatically shut off.
2. Raise the door to the WATER RESERVOIR FILL AREA and add the appropriate amount
of water (4 to 12 oz) to accommodate the size beverage you want to brew and close
the WATER RESERVOIR DOOR.
CAUTION: When adding water to the fill area for brewing, never exceed the 12 oz
mark on the WATER SIGHT GLASS or add more water than what you plan to use.
Always ensure your mug/cup will accommodate that amount of hot liquid.
The brewer is designed to pump in all water added and will dispense the same
amount of hot liquid into your cup (i.e. 10 oz of water added will result in 10 oz of
hot beverage in your cup).
3. Press the OPEN
your favorite K-Style Cup into the SINGE SERVE CUP HOLDER, close/lower the JAW back
to its original closed position. At this point, the BREW BUTTON will be flashing.
ICON, the UPPER BREW JAW will automatically raise. At this point,
ICON to release the brewer's UPPER BREW JAW, insert
5