Additional Information Specifications; Troubleshooting - Jumbo Touch Panel Remote Operation Manual

MUTE
M-POWER
DVD TV
M-POWER
PRECAUTIONS
- This is not a toy. Be sure to place this unit away from small children or pets.
- This unit is intended for indoor and household use in controlling the functions
of selected electronic devices.
- Do not drop or apply excessive mechanical shock to this unit. It may damage
the unit or cause malfunction.
- Do not place unit under direct sunlight or strong light source as it may
interfere with the normal operation.
- Do not immerse or expose to water or other liquid as it may damage the unit.
- Do not place the unit near heat sources.
Touch panel of the unit does not light up.
The unit does not control the device, but the
red LED indicator blinks when you press a
button.
The unit does not control the device and the red
LED indicator does not blink when you press a
button.
LEARN feature does not work.
M-POWER feature does not work.
SETTING UP M-POWER
M-POWER feature allows user to turn ON or OFF all programmed devices
with the press of one button!
1. Press and hold M-POWER and MUTE simultaneously for 3 seconds.
Release the buttons when LED turns solid red.
2. Press the device button that you want to bundle one at a time (ex. TV, DVD,
VCR
VCR, etc.). The LED will flash once each time you press the device button.
3. Press M-POWER to save the setting. The LED will turn off and go back to
normal operation mode. Setting has been completed.
4. Press M-POWER to turn on or off all devices at the same time.
Note: If the devices are in different conditions, ON device will be turned
M-POWER
off and OFF device will be turned on. The user can still use the regular POWER
button to turn on/off each individual device.
5. Erasing the M-POWER setting is similar to setting it up. Repeat step 1 but
only press one device button. PRESS M-POWER to save it. M-POWER will
only respond to one device as regular power button.
Note: Always refer to device's owner's manual. Some devices should stay ON all
the time.

ADDITIONAL INFORMATION SPECIFICATIONS

Operating distance: Approximately 25 feet
Battery: 4 x AAA batteries

TROUBLESHOOTING

Replace the batteries.
Make sure a correct device code is entered during setup.
Try all listed codes until you find a code that works properly
for your device.
Aim the remote control at your device. It should not be blocked
by other objects or be more than 25 feet from the device.
Make sure the batteries are installed properly or replace them.
Repeat the setup instructions for the LEARN feature. Make sure
both remote controls are placed head-to-head on a flat surface
within 1-2 inch distance.
The devices need to be set up before using this feature.
Repeat the setup instructions for M-Power feature.
7