Page 1
OWNER & OPERATOR INSTRUCTION MANUAL STEAM TABLES Model No. RST-2P, RST-2P-240 RST-3P, RST-3P-240 RST-4P, RST-4P-240 RST-5P, RST-5P-240 For Service contact: German Knife Inc. 1-800-500-3519 www.turboairinc.com www.turboairinc.com...
Page 2
TABLE OF CONTENTS ......................INSTALLATION ......................MAINTENANCE ............... 9-12 PARTS LISTS & EXPLODED VIEWS ....................WIRING DIAGRAM German Knife Inc. 4184 E. Conant St., Long Beach, CA 90808 Phone: 800-500-3519 Fax: 310-900-1066 www.turboairinc.com SHIPPING DAMAGE CLAIM PROCEDURE The equipment is inspected & crated carefully by skilled personnel before leaving factory. The transportation company assumes full responsibility for safe delivery upon acceptance of this equipment If shipment arrives damaged;...
Page 3
INSTALLATION UNPACKING: 1. Remove appliance from container. 2. Remove all protective packaging material. 3. Retain container and packaging material until the appliance is operated and found in good condition. 4. Check appliance for any shipping damage. If appliance shows any external or internal damages, promptly inform dealer/distributor where you bought your appliance.
Page 4
INSTALLATION INSTALLATION: 1. Operation temperatures permit safe installation of this steam table with in 1” of a combustible wall or partition. 2. Make sure that the operating location is in an area where the ambient temperature is held constant (minimum 70°F). Please avoid areas such as near exhaust fans and air conditioning ducts. 3.
Page 5
INSTALLATION Only for model RST-2P, RST-2P-240, RST-3P-240,RST-4P-240 and RST-5P-240, should be complying with safety related items. They are meant to protect the safety of users and prevent property damages. Please read the cautionary items carefully for correct use.
Page 6
INSTALLATION Only for model RST-3P, RST-4P and RST-5P should be complying with safety related items. They are meant to protect the safety of users and prevent property damages. Please read the cautionary items carefully for correct use.
Page 7
MAINTENANCE GENERAL INFORMATION: 1.Always clean equipment thoroughly before first use. 2. Check rating label for your model designation and electrical rating. GENERAL OPERATING INSTRUCTIONS: 1. All food equipment’s should be operated by trained personnel. 2. Do not touch or have any customers or employee come in contact with any surface labeled “...
Page 8
MAINTENANCE CLEANIN INSTRUCTIONS: 1. Never clean any electrical unit by immersing it in water. Turn unit off before surface cleaning. 2. Always clean equipment thoroughly before first use. Clean unit daily. Use warm, soapy water. Mild cleansers and plastic scouring pads may be used to remove baked- on food and water scale. Turn off electrical units before cleaning or servicing.
Page 9
PARTS LISTS & EXPLODED VIEWS Name Name 2p 3p 4p 5p 2p 3p 4p 5p 240V Thermostat Top Board 120V Thermostat Heating Element Holder Indicator Light Insulation Side Board 8 10 Bottom of The Knob Insulation Tank Knob Insulation Board Contactor Insulation Board Holder Bullet Leg...
Page 10
PARTS LISTS & EXPLODED VIEWS Name Name 2p 3p 4p 5p 2p 3p 4p 5p 240V Thermostat Top Board 120V Thermostat Heating Element Holder Indicator Light Insulation Side Board 8 10 Bottom of The Knob Insulation Tank Knob Insulation Board Contactor Insulation Board Holder Bullet Leg...
Page 11
PARTS LISTS & EXPLODED VIEWS Name Name 2p 3p 4p 5p 2p 3p 4p 5p 240V Thermostat Top Board 120V Thermostat Heating Element Holder Indicator Light Insulation Side Board 8 10 Bottom of The Knob Insulation Tank Knob Insulation Board Contactor Insulation Board Holder Bullet Leg...
Page 12
PARTS LISTS & EXPLODED VIEWS Name Name 2p 3p 4p 5p 2p 3p 4p 5p 240V Thermostat Top Board 120V Thermostat Heating Element Holder Indicator Light Insulation Side Board 8 10 Bottom of The Knob Insulation Tank Knob Insulation Board Contactor Insulation Board Holder Bullet Leg...
Page 14
Radiance Heavy Duty Microwaves- HD Series (TMW-1200HD, TMW-1800HD) Any part covered under this warranty that is found by German Knife / Radiance to have been defective within the above time period is limited to the repair or replacement, including labor charges, of defective parts or assemblies.
Need help?
Do you have a question about the RST-2P and is the answer not in the manual?
Questions and answers