Battery Saver; Code Saver; Code Search - Maxview URC6D User Manual

1.
2
3
4
5
6
7
8
9
10
11
12

Code Search

If your product does not respond after you have tried all the codes for
your brand, or if your brand is not listed, try searching for your code
by following these steps.
1. Manually turn on the device (TV, VCR, etc.) to be controlled.
2. Press and hold the SET UP button until the red indicator stays
on, then release the SET UP button.
3. Press and quickly release the desired mode button (TV, VCR, etc.).
The red indicator blinks off once.
4. Press the PROGRAM UP button repeatedly (up to 300 times) until the
device to be controlled changes channel. The red indicator blinks off
with each button press. If you accidentally overshoot the code required,
press the PROGRAM DOWN button to backtrack through the library
until the device changes channel. Pressing PROGRAM UP changes
direction to forward again.
5. Press and release MUTE to install the code.
Most users will store VCR codes under the VCR button, Cable codes under
SAT/CABLE, etc. If, for example you want to store a VCR code under
SAT/CABLE, first follow the procedure for Direct Code Entry
and press SAT/CABLE in step 2 of Direct Code Entry, then enter any
VCR code in step 3 of Direct Code Entry. Then follow the steps above
for Code Search. Note: If the device does not have a PROGRAM UP button,
use PLAY (VCR only) or POWER instead. Code Search starts from the
currently stored four digit number under that mode.
Note: The REC button must be
pressed TWICE to record from
21
your VCR. For some brands of
VCRs, you might need to press
the REC button once, then press
it again for three seconds.
20
Set Up Battery Installation
On the back of the remote, push
19
down on the tab and lift the cover
off. Match the batteries to the
+ and - marks inside the battery
18
case, then insert 2 AAA Alkaline
17
batteries. Press the battery cover
16
back into place.
15

Battery Saver

14
Your remote automatically turns
itself off if the buttons are depressed
for more than 30 seconds. This will
save your batteries should your
remote get stuck in a place where
the buttons remain depressed
(e.g: between the sofa cushions).
13

Code Saver

Codes are stored in permanent
memory while you are changing
batteries so you will not lose any
codes stored in the remote while
you are changing batteries.
Power-On Default
The remote powers on in TV mode.
3