Naxa NHS-2012A Manual

Naxa NHS-2012A Manual

32" soundbar with bluetooth

Advertisement

32" Soundbar with Bluetooth
MODEL:NHS-2012A
PLEASE READ CAREFULLY BEFORE OPERATING THIS EQUIPMENT
KEEP IT IN A SAFE PLACE FOR FUTURE REFERENCE

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the NHS-2012A and is the answer not in the manual?

Questions and answers

Summary of Contents for Naxa NHS-2012A

  • Page 1 32" Soundbar with Bluetooth MODEL:NHS-2012A PLEASE READ CAREFULLY BEFORE OPERATING THIS EQUIPMENT KEEP IT IN A SAFE PLACE FOR FUTURE REFERENCE...
  • Page 2 CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE ELECTRIC SHOCK, DO NOT REMOVE THE COVER (OR BACK). NO USER SERVICEABLE PART INSIDE, REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. DANGEROUS VOLTAGE:The lighting flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage”...
  • Page 3 Reorient or relocate the receiving antenna.  Increase the separation between the equipment and receiver.  Connect the equipment into an outlet on a circuit different from that to  which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. ...
  • Page 4 (6) Clean only with dry cloth The appliance should be cleaned only as recommended by the manufacturer. (7) Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. Slots and openings in the cabinet and in the back or bottom are provided for ventilation, to ensure reliable operation of the product and to protect it from overheating.
  • Page 5 (15) Power source This product should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supply to your home, consult your appliance dealer or local power company.
  • Page 6 (21) Replacement parts When replacement parts are required, be sure the service technician uses replacement parts specified by the manufacturer or those that have the same characteristics as the original parts. Unauthorized substitutions may result in fire or electric shock or other hazards. (22) Safety check Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in...
  • Page 7: Placement And Mounting

    PLACEMENT AND MOUNTING 1. Placing the device on table - Ventilation When placing the Sound Bar on an entertainment center, bookshelf, or any type of enclosed space, be sure to allow at least 2-3 inches of space around the Sound Bar for ventilation.
  • Page 8 2.1 Mounting to a wooden wall (screws not included) A. Mark the position of the mounting screws on the wall using a pencil. B. Drill the screws directly into the marks that you have made on the wall and leave approx. 0.3 inches length to hook the sound bar. C.
  • Page 9: Location Of Controls

    LOCATION OF CONTROLS Front View 1. Indicator 3. Speaker 2. Remote Sensor 3. Speaker Rear View A U X I N 4. AUX IN Jack 5. DC IN Jack Top View Standby Play Vol- Vol+ /Source /Pause 6. Standby/Source 9. Volume Up Button Button 8.
  • Page 10: Remote Control

    REMOTE CONTROL S ANDB NHS-2012A (Play/Pause) Button STANDBY Button VOL - (Volume Down) Button (Mute) Button VOL + (Volume Up) Button 3. SOURCE Button (Previous) Button (Next) Button...
  • Page 11: Battery Installation Of Remote Control

    BATTERY INSTALLATION OF REMOTE CONTROL USING AT FIRST TIME ●Remove and discard the insulation as figure on the right. film REPLACING BATTERY 1. Push and slide out the battery holder as figure 1 below. 2. Replace the battery with a new CR2025 button cell as the polarity R2025 OPEN markings on the rear of the Remote Control.
  • Page 12: General Operation

    GENERAL OPERATION 1. Connect the AC/DC adapter to the unit and wall outlet. The red indicator will light and the unit is in standby mode. 2. Press and hold the Standby/Source button on the unit or press the STANDBY button on remote control to turn on the unit. Press the Standby/Source button on the unit or press the SOURCE button on remote control repeatedly to switch to desired mode.
  • Page 13: Bluetooth Pairing And Connection

    3. Power on the external Bluetooth device and set Bluetooth to searching mode. When appears, select it and start pairing. " NAXA NHS-2012A " After paired, the indicator will stop blinking and a voice tone sounds "Paired". (For details on pairing procedures, please refer to the user's manual of your Bluetooth device.)
  • Page 14 LISTEN THROUGH AUX IN An external (Auxiliary) audio source (ie.,personal CD player or MP3 player) can be connected to this unit and heard through the speakers. 1. Plug one end of the Aux In cable into the AUX IN jack on the rear of the unit. 2.
  • Page 15: Troubleshooting

    TROUBLESHOOTING POSSIBLE SOLUTION SYMPTOM POSSIBLE CAUSE Connect the power AC/DC adapter No power Power AC/DC Adapter not connected to the unit or wall outlet. The unit is in standby mode Press and hold Standby/Source button on the unit or press button on remote control to turn on the unit from Standby mode.
  • Page 16: Specifications

    SPECIFICATIONS Power Source............DC9V 1300mA Audio Power....................2X3W Bluetooth Effective Range in Open Area.........Up to 32 feet Remote Effective Range..............Up to 16 feet ACCESSORIES 1 x AC/DC Adapter 1 x Remote Control 1 x User's Manual 1 x 3.5mm AUX to RCA Cable SPECIFICATIONS AND ACCESSORIES ARE SUBJECT TO CHANGE WITHOUT NOTICE is a trademark on a registered trademark of Bluetooth...

Table of Contents