QTRONIX SCORPIUS RF User Manual page 3

Scorpius KIV (P) & Lynx KIV (p) SPECIFICATIONS
ⅠSetup Guide
Reset ID before using
Step 1: Connect the receiver to your computer
Step 2: Push the "CONNECT" button on the receiver.
Step 3: Push the button on the back of the mouse (in upper left corner).
Please note that this step must be completed after Step 2 within 8
seconds.
Step 4: Move pointer,w hen the receiver and the mouse are connected, the
LED will blink , the setting has been completed.
Step 5: Please go back to Step 2 if the LED does not behave as that in
Step 4.
Step 6: Push the "CONNECT" button on the receiver.
Step 7: Push the button on the back of the keyboard (in upper left
corner). Please note that this step must be completed after Step 6
within 8 seconds.
Step 8: Push "Space" key ,when the receiver and the keyboard are
connected, the LED will blink , the setting has been completed.
Note: If same ID is used by other users and causes interference, just
repeat this reset procedure .
3