Set The Sleep Timer; Play From An External Device; Headphone; 6Shflàfdwlrqv - Philips DCM3065 User Manual

Set the sleep timer

This unit can switch to standby automatically
after a set period of time.

When the unit is turned on, press 6/((3
7,0(5 repeatedly to select a set period of
time (in minutes).
» When sleep timer is activated,
displayed.
7R GHDFWLYDWH VOHHS WLPHU

Press 6/((37,0(5 repeatedly until [OFF]
(off) is displayed.
» When sleep timer is deactivated,
disappears on the display.

Play from an external device

You can also listen to an external audio device
through this unit.

Press MP3 LINK to select the MP3 link
source.

Connect the supplied MP3 link cable to:
‡ the MP3 LINK connector (3.5mm) on
the unit.
‡ the headphone connector on an
external device.
3
Start to play the device (see the device's
user manual).

Headphone

Plug headphones (not supplied) into the
connector on the unit to listen through the
headphones.
9 Product
information
Note
‡
Product information is subject to change without prior
is
notice.
6SHFLÀFDWLRQV
$PSOLÀHU
Maximum Output Power
)UHTXHQF\ 5HVSRQVH
Signal to Noise Ratio
MP3 link input
7XQHU
Tuning Range
Tuning grid
FM sensitivity
- Mono
Total Harmonic
Distortion
Signal to Noise Ratio
Number of presets
Speakers
Speaker Impedance
Speaker Driver
Sensitivity
58W RMS
60 Hz - 16 kHz,
±3 dB
>65dBA
500mv, 20kohm
FM: 87.5 - 108 MHz
50 KHz
26 dB
<2%
>55 dB
20 (FM)
8 ohm
2 X 2.5" full range
>82 dB/m/W
EN 17