Troubleshooting - Philips DCM850/12 User Manual

10 Troubleshooting

Warning
‡
Never remove the casing of this apparatus.
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
apparatus, check the following points before
UHTXHVWLQJ VHUYLFH ,I WKH SUREOHP UHPDLQV
unsolved, go to the Philips web site (www.
philips.com/welcome). When you contact
Philips, ensure that the apparatus is nearby
and the model number and serial number are
available.
1R SRZHU
‡ (QVXUH WKDW WKH $& SRZHU SOXJ RI WKH XQLW
is connected properly.
‡ (QVXUH WKDW WKHUH LV SRZHU DW WKH $& RXWOHW
‡ To save power, the unit switches to standby
automatically 15 minutes after a play
reaches the end and no control is operated.
No sound
‡ Adjust the volume.
1R UHVSRQVH IURP WKH XQLW
‡ Disconnect and reconnect the AC power
plug, then turn on the unit again.
5HPRWH FRQWURO GRHV QRW ZRUN
‡ %HIRUH SUHVVLQJ DQ\ IXQFWLRQ EXWWRQ ÀUVW
select the correct source with the remote
control instead of the main unit.
‡ Reduce the distance between the remote
control and the unit.
‡ Insert the battery with its polarities
(+/– signs) aligned as indicated.
‡ Replace the batteries.
‡ Aim the remote control directly at the
sensor on the front of the unit.
No disc detected
‡ Insert a disc.
20 EN
‡ Check if the disc is inserted with the print
side facing inward.
‡ Wait until the moisture condensation at
the lens has cleared.
‡ Replace or clean the disc.
‡ 8VH D ÀQDOL]HG &' RU FRUUHFW IRUPDW GLVF
&DQQRW GLVSOD\ VRPH ÀOHV LQ 86% GHYLFH
‡ 7KH QXPEHU RI IROGHUV RU ÀOHV LQ WKH 86%
device has exceeded a certain limit. This
phenomenon is not a malfunction.
‡ 7KH IRUPDWV RI WKHVH ÀOHV DUH QRW
supported.
USB device not supported
‡ The USB device is incompatible with the
unit. Try another one.
Poor radio reception
‡ Increase the distance between the unit and
your TV or VCR.
‡ Fully extend and adjust the FM antenna.
7LPHU GRHV QRW ZRUN
‡ Set the clock correctly.
‡ Switch on the timer.
Clock/timer setting erased
‡ Power has been interrupted or the power
cord has been disconnected.
‡ Reset the clock/timer.