Download Print this page

Challenge E0111R Operating Instructions page 3

3kw

Advertisement

Use a damp cloth to wipe the exterior of the heater to remove dust and dirt.
Use a vacuum cleaner to remove dust and fluff from the inlet and outlet grilles.
Ensure the heater is dry before plugging back into the mains supply.
If the heater has collected dust or dirt inside the unit or around the element, have the unit cleaned
by a qualified service agent. Do not operate the heater in this condition.
CONNECTION TO POWER
Before Switching on make sure that the voltage of your electricity supply is the same as that indicated
on the rating plate
MAIN CORD
This appliance may be fitted with a non-rewireable plug.
If it is necessary to change the fuse in a non-rewireable plug the fuse cover must be refitted. If the
fuse cover is lost or damaged, the plug must not be used until a replacement is obtained.
It is important that the color of the replacement fuse cover corresponds with the colour marking on the
base of the plug.
If the plug has to be changed because it is not suitable for your socket, or becomes damaged, it
should be cut off and an appropriate plug fitted following the wiring instructions below.
The plug removed must be disposed of
safely as insertion into a 13A socket is
likely to cause an electrical hazard. For
your own safety read the following
instructions carefully before attempting
to connect this unit to mains. The wires
in this mains lead are coloured in
accordance with the following code:
BLUE = NEUTRAL
BROWN – LIVE
IMPORTANT
As the colours of the wire in the mains
lead of this appliance may not correspond with the coloured markings identifying the terminals in your
plug, proceed as following:-
The wire which is coloured blue must be connected to the terminal which is marked with the letter N or
coloured black.
The wire which is coloured brown must be connected to the terminal which is marked with the letter L
or coloured red.
No connection is to be made to the earth terminal of the plug.
If a 13 Amps (BS 1363) plug is used, it must be fitted with a 13 Amp Fuse conforming to BS1362 and
be ASTA approved. If in doubt consult a qualified electrician who will be pleased to do this for you.
Waste electrical products should not be disposed of with household waste. Please
recycle where facilities exist. Check with your local authority or retailer for recycling
advice.
BLUE
(NEUTRAL)
N
OUTER
SLEEVE
FUSE
BROWN
(LIVE)
L

Advertisement

loading