Advertisement
area.
Do not store appliance while it is still hot.
The appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for their
safety.
Young children should be supervised to ensure they do not play with the appliance.
The appliance must not be located immediately below a socket-outlet.
Do not use this appliance in the immediate surrounds of a bath, a shower or a swimming pool or
other liquids.
If the supply cord is damaged, it must be replaced by a qualified electrical person in order to avoid
a hazard.
Do not use this appliance outdoors, or on wet surfaces. Avoid spilling liquid on the appliance.
Always switch off the heater at the controls and at the power outlet then unplug heater from the
power outlet when not in use.
Do not use this heater with programmer, timer or any other device that switches the heater on
automatically since a fire risk exists if the heater is covered or positioned incorrectly.
Do not run the cord under carpeting or cover the cord with run runners or the like. Arrange cord
away from traffic areas and where it will not be tripped over.
Important-This heater is intended for floor use only. Do not mount on ceiling or walls.
Do not operate the heater near curtains, as the material could be sucked into the air vents.
The appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
appliance by a person responsible for their safety.
OPERATING INSTRUCTIONS
Always choose a safe location for the heater, keeping in mind the safety precautions outlined.
How to operate
concerning use of the
1. Remove heater from its carton and unwind the cord to its full length.
2. Place heater on a firm level surface, in a stable upright position.
3. Make sure the function knob is turned to OFF "0 "
4. Plug the cord into a 230-240V AC power outlet. To avoid and electrical circuit overload,
be sure that no other appliances are plugged into the same circuit with your heater.
Fan
Turn fan on by turning the function knob to "
position.
You can use the fan at any time during the year to circulate the air within the room.
Heating
Turn the function knob to "
"or 1500W heat setting and "
For greater economy, use the 3000W heat setting initially and then switch to the 1500W
heat setting.
For the 1500W and 3000W heat settings the fan remains at the same settings, only the
elements used changes to create the greater/lesser heat flow.
THERMOSTAT CONTROL IN FUNCTION KNOB
The thermostat is used to control the room temperature. It acts as a switch and does not vary
the amount of heat output from the heater.
Temperature setting
Turn the function knob to high temperature setting.
Once the desired room temperature is reached, slowly turn the thermostat knob clockwise
until you hear a click. The heater will now stop operating.
The heater will turn on and off automatically maintaining the room temperature that you
have set.
OVERHEAT SAFETY DEVICE
Your heater is fitted with a safety device the switches off the heater in the event of overheating.
Should the heater stop working, turn the heater off and inspect for blockage of air inlet or outlet.
Wait at least 5 minutes for the protection system to reset before attempting to restart the heater.
If the heater fails to operate or the safety device switches the heater off again, return heater to
your nearest service center for examination or repair.
TIP OVER SWITCH
The heater is fitted with a safety switch which cuts the heater off if it falls over. This switch is
located under the base. Standing the unit on the long pile carpet may not activate the switch.
CARE AND MAINTENANCE
The heater requires regular cleaning to ensure trouble free operation:
Always turn off unplug the heater from the mains supply before cleaning.
" and rotating the thermostat to maximum
" for 3000W heat setting.
Advertisement
