Remote Control / Strapping Amplifiers For Ec 1200.1D - Eton EC 300.2A User Manual

REMOTE LEVEL CONTROL
(EC 1200.1D Only)
Mounting and installation
1. Find a location, either under the dash or near
the center console, that gives easy access to
the remote.
2. Using the screws supplied, install the mounting
clip with the tabs towards the back.
3. Route the cable for the remote and connect to
both the remote and amplifier.
4. Slip the remote onto the mounting clip until it
snaps into place.
STRAPPING AMPLIFIERS (EC 1200.1D Only)
CAUTION: Two EC 1200.1 D amplifiers that are strapped together are not
recommended for impedance loads below 2.
1. Select which amplifier of the two will be the master. and set the Master/Slave switch "out".
NOTE: Only adjustments on the master amplifier will effective in functions.
2. Connect RCA cables from the source signal to the input connection on the master amplifier.
3. Set the Master / Slave switch on the slave amplifier to the "in" position.
4. Connect a RCA cable from the MAS OUT connector on the master amplifier to the SLV IN
connector on the slave amplifier.
5. Connect one of the negative (-) speaker outputs from the master amplifier to one of the
negative (-) speaker outputs on the slave amplifier using a 10 gauge wire (minimum).
6. Connect one of the positive (+) speaker outputs from the master amplifier to the positive (+)
terminal of the speaker being use.
7. Connect one of the positive (+) speaker outputs from the slave amplifier to the negative (-)
terminal of the speaker being use.
Master
Slave
7