Operation; Adjusting Level; Adjusting Crossover (X-Over); Subsonic Filter For Ec 1200.1D - Eton EC 300.2A User Manual

O P E RAT I O N

ADJUSTING LEVEL

To adjust the level setting, turn the amplifier levels all the way down. Turn the source unit volume up
until distortion is audible and then turn it down a bit until the distortion is inaudible This will be about
two thirds all the way up on most source units Next, turn the amplifier level setting until once again
distortion is audible and then back it down until the distortion is inaudible.
NOTE:
For a more in depth setting procedure, contact ETON Technical Support

ADJUSTING CROSSOVER (X-OVER)

Model EC 1200.1D only
Turn the crossover adjustment knob all the way down. With the system playing at normal
listening level, turn the crossover adjustment knob up slowly until the desired crossover point is
achieved.
All Other Models
Placing the switch in the HPF position sets the amplifier to the high pass mode, enabling
frequencies above the cut-off point to pass, adjustable between 50-500Hz or 500 Hz – 5KHz.
Placing the switch in the Flat position sets the amplifier to the all pass mode, preventing any
crossover adjustment, allowing all frequencies to pass.
Placing the switch in the LPF position sets the amplifier to the low pass mode, enabling
frequencies below the cut-off point to pass, adjustable between 50-500Hz or 500 Hz – 5KHz.
Turn the crossover adjustment knob all the way down. With the system playing, turn the crossover
adjustment knob up slowly until the desired crossover point is achieved.
SUBSONIC (EC 1200.1D Only)
A variable 15-40Hz high pass filter designed to prevent frequencies below the audio range from being
applied to the subwoofer from the amplifier.
Set this to your personal preference while listening to the system.
Crossover
Crossover Level
EC 1200.1D
Crossover
Level
Crossover
Level
Subsonis
6