General Instructions - AEG SANTO 2732-4I Operating And Installation Instructions

GB
IMPORTANT!
If the fridge-freezer you have purchased is replacing
an older refrigerator or freezer still fitted with a snap
catch or lock, you should render this lock unservice-
able before throwing the appliance away or putting it
out for environment-friendly refuse collection. In this
way you can prevent children locking themselves in
when playing and thus endangering their lives.
Please make sure that the pipelines of your fridge-
freezer are not damaged before collection for envi-
ronment-friendly disposal.
Appliance packaging
information
All used materials are environmentally compatible!
They can be safely disposed of or burnt in a refuse
incinerator!
Regarding the materials: the plastics can also be
recycled and are marked as follows:
>PE< for polyethylene e.g. as used in the outer
wrapping and bags inside
>PS< for polystyrene foam e.g. as used in the
packing; this material is basically CFC-free
The cardboard parts are made of waste paper and
should be put back into the waste paper collection
system.

General instructions

You have just purchased a home fridge-freezer
which has been produced according to the stand-
ards applicable to these appliances.
During manufacture, the necessary measures have
been taken as required by the Appliance Safety Act
(GSG), the Accident Prevention Regulations for
Refrigerating Installations (VBG 20), and the Specifi-
cations of the Institute of German Electrical Engi-
neers (VDE).
The refrigeration circuit has been checked for
leakage.
This appliance complies with the following EC
Directives:
- 73/23/EEC of 19.02.1973 - Low-Voltage Directive
- 89/336/EEC of 03.05.1989 (including Amendment
Directive 92/31/EEC) - EMC (Electromagnetic
Compatibily) Directive.
Before starting up, we recommend you to read
the following Operating Instructions, since only
by doing so can you benefit from all the advantages
offered by your fridge-freezer. Please unfold the
14
illustration pages on the cover to enable you to
compare the text and pictures alongside.
Removing the adhesive tapes
The doors are secured to the housing with adhesive
tapes. Remove any adhesive tape residues with a
suitable petroleum-based cleansing agent.
Commercial use
Should you use your home fridge-freezer commer-
cially or for purposes other than refrigeration,
freezing, and deep frozen storage of food and
drinks, you must observe the legal requirements
applicable to your area.
Location
The most suitable location is a dry room which can
be ventilated.
The refrigerating unit needs a good supply of air and
proper ventilation in order to function properly.
Please make sure that the air-vents in the plinth
underneath the kitchen cabinet and the air-shafts
behind it are not covered over or blocked.
Ambient temperature has an effect on the power
consumption of the unit. The appliance should
therefore:
- not stand in the direct sunshine, or close to a
radiator or cooker
- stand in a position where the ambient tempera-
ture corresponds with the climate category for
which the appliance is designed.
You will find data on this on the rating plate, which is
in the interior of the appliance on the left hand side.
It will consist of one of the following:
Climate category
SN
N
ST
T
Appliance and installation
dimensions
Fig. 1
2
A = 200 cm air outlet
2
B = 200 cm air inlet
C = Split kitchen unit door
D = Depth overall
E = Height overall
Ambient temperature
from ... to ...
+10 to +32°C
+16 to +32°C
+18 to +38°C
+18 to +43°C.