Battery Installation; Charge Method - XciteRC High-Speed Racebuggy 2WD User Manual

Battery installation

• Remove the battery cover of the transmitterwith a crisscross screwdriver.
• Properly install 4 x AA batteries.
EN
• Fix the battery cover of the transmitter.

Charge method

• Please take out the vehicle shell when it needs to
charge.
• Push the power switch (at the bottom of the vehicle)
to "OFF".
• Push the power switch of remote controller to "ON". (the red LED light flashes).
• Insert the charging plug of the transmitter into the vehicle body.
Charging plug
Make one side
backwards
• When it charges, the red LED light changes to green (normally on), once charge finishes, the light changes
to flashing red.
• The charge time depends on the battery capacity. The common charge
time is about 60 minutes.
• When charge finishes, push the power switch of transmitter to "OFF" and
remove the charging plug from the body.
18
Power switch
Backside
AA Alkaline
batteries
30801000/2000/3000 - High-Speed Racebuggy 2WD
RC-System
Transmitter
Power
switch