LENCO SCD-330 User Manual page 8

HOW TO USE THE CD/MP3 MUSIC PROGRAMMING FUNCTION
You can program a desired sequence of your favorite music. Make sure the unit is in stop mode.
Pressing the PROG (3) button on the unit, the LCD will show "PO 1" (See Figure 5).
You can use the PREVIOUS (5) OR NEXT (6) button to scroll through the songs of the CD/MP3
Select the song number of your choice and then press PROG (3) again.
If you want to program another song then repeat the above step. (You can program up to 20 songs from CD
or 99 songs from MP3).
If you are finished with programming, press the PLAY (7) button to start playing the programmed sequence.
The program playback will be displayed on the LCD as shown in Figure 6.
By pressing the STOP (4) button once, you can stop the programmed playback temporarily. By pressing the
STOP (4) a second time, the unit will turn back to normal play mode.
STEREO PHONE JACK
For private listening, insert a 3.5mm headphone into the green coloured ST.PHONE JACK (18).
The speaker output will be cut off automatically.
CAUTION: LISTENING AT HIGH VOLUME FOR A LONG TIME COULD DAMAGE THE USERS HEARING.
BLUETOOTH OPERATION
1. Push the function switch (20) to the "BLUETOOTH" position, the Bluetooth indicator will flash.
2. Power on the mobile phone or other Bluetooth device. When the device finds the SCD-330, it displays
the name "SCD-330". (NOTE: If the Bluetooth version of the device is too low, a password could be
needed. In that case enter the password "0000") and choose connect to establish connection.
3. Now you can play the music of the mobile phone by Bluetooth.
Note: If no Bluetooth device is detected/connected within 5 minutes, it will go into sleep mode and the
Bluetooth indicator will flash slowly.
MAINTENANCE
To avoid battery spillage causing damage to the set, remove the batteries when the unit is not being used
for a long time.
ACCESSORIES
Instruction Manual
AC power cable
1 pc
1 pc
8