Wire Color Table Of The Reader; Operation - GE GE616 Installation And Operating Manual

GE616 Proximity Reader

7. Wire Color Table of the Reader

POWER
Power(DC +5V~+17V)
Power(DC Ground)
INPUT
Buzzer control input
LED control input
OUTPUT(Wiegand Format)
Wiegand Data-0
Wiegand Data-1

8. Operation

8-1. Apply power and you can see Red LED is on indicating the
reader is in standby.
8-2. Present proximity card to the reader until you hear beep
sound and the LED is changing the color to Green
simultaneously and the reader send RF card data to the
controller then LED changes the color to Red again for next
reading.
8-3. LED Control
To change the LED colors, you may connect LED Control
Input (Yellow wire) to power ground then the Green LED is
on indicating the reader is in standby.
Present proximity card then the LED changes the color
to Red simultaneously then Green again for next reading.
Last Update August 24, 2005
DC(+)
DC(-)(GND)
BUZZER
LED
Data-0
Data-1
8
Red wire
Black wire
Blue wire
Yellow wire
Green wire
White wire