(If no LogCard present, data is stored in you press [CHANGE DISPLAY] a Memory.) Use the “Concept2 LogCard Utility” to back up new display is shown. See below. your LogCard data to your PC. (USB cable provided) Note: A LogCard is provided with every Performance Monitor (PM).
Page 4
Racing: (PM4 Only) The PM4 enables you to set up races with up to eight PM4- 1-4 racers equipped indoor rowers without using a computer. This can be done wirelessly or by 1530 using Ethernet patch cables available from Concept2. If using cables, be sure to plug 1:55 them in before starting the race. /500 1:53.2...
Battery compartment: Loosen screw and press 1) Remove batteries or battery pack from the thumbstrike in direction shown to open. PM3 or PM4 if monitor will not be used for a period of four months or more. 2) When changing batteries, information in the PM will be lost if the batteries are out for more than a few minutes.
1. If the PM malfunctions or does not “wake up,” try one of the following: • Insert a paper clip (PM3) or pen/pencil tip (PM4) into the reset hole on the back and press lightly. See below. • Remove the batteries for 30 minutes and insert two new alkaline D-Cell (LR20) batteries.
Page 7
FCC & IC compliance information: WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.