eisenblatter ROLEI BE 5 Operating Instructions

Operating Instructions

CE-tested – is corresponding to the directions 89/392 and 93/68 EEC
1. Elektric connection
three-phase motor 380 V - 50 Hz
(alternative 220 V - 60 Hz)
Pay attention to correct sense of rotation!
The abrasiv e wheels hav e to run one to the other
(see arrow at the machine casing !)
2. Adjustment of the sheet thickness
Release lock ing screws at the bottom of the guide plate (1),
adjust slot width by means of the setting screws (2) in a
manner that the work piece can be mov ed easily –
retighten then lock ing screws (1).
3. Setting to work
Switch-on the machine :
Step I for slight burrs
step II for heavy burring
4. Adjustment of the abrasive wheels
Turn abrasiv e wheels (mop) upwards by means of the hand-wheel (right-hand rotation) until a grinding noise is heard,
turn then hand-wheel (3) to the left until the wheels are
"running free" without any noise (the machine is correctly adjusted now). The sheet parts can be pushed now from one
side through the guide prism to burr them neatly at both sides.
5. Changing of the abrasive wheels
A ttention: Both driving shafts are left-hand threaded!
Release the nuts and tak e off the abrasiv e wheels with the clamping cov ers.
Pay attention to sense of rotation when new wheels are mounted. Retighten the nuts!
6. Maintenance
The machine (gear) is maintenance-free!
Wheel dust should be remov ed from the machine daily!
If necessary remov al by suction.
1
3
2