Electrolux ESF65054 User Manual page 35

2. Use the screws (on the top or on the
side) to install the appliance in position.
Make sure that the screws are tight.
TO ADJUST THE LEVEL OF THE
APPLIANCE
A correct level of the appliance lets the door
to close and seal correctly.
If the level of the appliance is not correct,
the door catches on the sides of the cabi-
net. Loosen or tighten the adjustable feet to
adjust the level of the appliance.
After the adjustment of the level of the ap-
pliance, assemble the adjustable plinth on
the appliance.
Make sure that the bottom of the adjustable
plinth is aligned with the ground.
WATER DRAIN CONNECTION
Connect the water drain hose to:
• The sink spigot and attach it under the
work surface. This prevents that the
waste water from the sink goes back into
the appliance.
• A stand pipe with vent-hole. The internal
diameter must be minimum 40 mm.
max 85 cm
min 40 cm
Remove the sink plug when the appliance
drains the water to prevent that the water
goes back into the appliance.
The drain hose extension must not be lon-
ger than 2 m. The internal diameter must
not be smaller than the diameter of the
hose.
If you connect the water drain hose to a
trap spigot under the sink, remove the plas-
tic membrane (A). If you do not remove the
membrane, remaining food can cause a
blockage in the drain hose spigot
A safety device impedes the dirty water
to go back into the appliance. If, the
spigot of the sink has a 'non-return
valve', this can cause the appliance to
drain incorrectly. Remove the non-re-
turn valve.
electrolux 35